开云体育

I ordered mine from ST-EC before I knew about the Hugen version. However, it appears that I received the Hugen version from ST-EC for $48.

For now, I am going to leave a short SMA cable permanently connected to avoid wear and tear on the NanoVNA SMA connector.

Larry, After a "pause" command all scanning is suspended and only the UI and communication tasks run interrupt driven. Using the "scan" command I implemented no updating of the ui is done while

Did you try turning power off and then back on?

There has been some mention of running the NanoVNA in headless mode - ie:through the USB interface using console commands. How much processing power would be recovered by disabling and/or removing

Are you still able to make changes to the settings via the touch screen or connected PC?

No clue, test?

All dotNet versions??

Its 32 bit and you will need dotNet and VC++ 2010 runtime

/g/nanovna-users/files/NanoVNA%20PC%20Software/TAPR%20VNA/VNAR4.2.zip Hello Erik Just for fun I am trying to install your app using Wine on Linux Mint 19.2 64 bit. What M$

Yes, both dutch, I'm waiting for AT to get my ham licence. Will implement a fix for the mentioned error. Its probably a .dotnet error. Is you windows language set to Dutch. Can you take the manual and

qrp.ddc, The plot I attached was for a scan I had on hand called "rg316-rg6u-rg58-50R.s1p", sorry for the confusion. The plots for the two files in your original message are attached. They don't seem

Yes, after quite extensive BNC usage over 30 years, I experienced fewer than a half dozen failures requiring more than cleaning/corrosion removal, but more SMA failures from only occasional usage

Hi guys, mine Nanvna seemed like it was working but I think I messed some setting. If I have nothing connected to the device I see a yellow waveform on CH0 and it reads 10db/ -83.75db and the line

Hello Erik, Found the trick. I have to check Apply calibration , Even with the white nano display taprvna is communicating and displaying the right graphs. Is there a possibility to ignore the

[email protected]> wrote: You wrote sometime later that people are reading more into this than you intended. I think you need to set out your aims more clearly, as I am completely

Ok Erik, During scanning sometimes a window pops Up with Error De indeling van de invoertekenreeks is onjuist. I have to push [OK] to let the software continue Are we Both dutch?

Hi Reg Sensible argument, which will lead to a conclusion that all purchased are equally poor, as you will include poorly build as well the good quality ones. May I suggest you to try to sort your

Yes Scanning hoe from 6 to 8 MHz View rectangular Trace S11 magnitude stays 0 Trace S11 Phase graph Looks ok, anyway the same values as the nano.

Did you switch the S11 magnitude on in the menu?