开云体育

As stated, the purpose of placing the second 50 ohm load on port S21 is to improve the isolation calibration. The next best thing (which is fine) is to put the open SMA calibration connector on the

Hi, If one has that basic soldering skills you could build these for less than 4USD, specially if you just build the test fixture. Cheers! A sábado, 18/04/2020, 11:43, hwalker

Я получил прибор в России, доставка из Китая две недели!

Thanks, that looks great How do you calculate complex choking impedance? Cheers! A sábado, 18/04/2020, 10:44, Aleksander Shalygin <shalygin@...> escreveu:

A VNWA like Testboard kit is being sold as an accessory for the NanoVNA on AliExpress for $10.00 usd (currently offering 5% discount). Assembly is required so some basic soldering skills are needed.

My experiments.

Hi Run I did not realize before now you bought a nonoVNA ? Kind regards Kurt -----Oprindelig meddelelse----- Fra: [email protected] <[email protected]> P? vegne af Ron Sendt: 18. april

Hi Run Go to the homepage of Gun thard Kraus and read his excellent document about NanoVNA and the program NanoVNA-saver which is a must to install http://www.gunthard-kraus.de/ NanoVNA-saver to find

I actually prefer the software, although it's true that if I were on the roof, I'd prefer not to have a computer dangling. but in the shack, the ability to view and save and "mouse around" the images,

I just got a new Nano VNA and I see stuff on YouTube but I'm not sure where to start. Later Don va7dgp/va7qu [email protected]> wrote:

So who was telling the truth? The nanoVNA or the SWRmeter? If the driven element was 2 cm too long, then the nanoVNA was right when it said that resonance was at 142 MHz?

And so much more!? It also allows you to do sweeps with as many points as you like, as opposed to the 101 point limit on a standalone NanoVNA.

I think the software runs on most Windows iterations.? I think it's nanosaver.? Read the blurb that comes with the unit. NanoVNASaver | NanoVNA | | | | NanoVNASaver | NanoVNA NanoVNASaver is

Thanks, Bob! BTW, my laptop is Windows 7 -- Ron WA0RJ

I started with a program called nanoSaver or similar name.? But then I decided I'd rather use the nano by itself.? The display isn't that small and it's a lot nicer not having a cord dangling. Bob

Hi, I'm Ron WA0RJ. I just ordered a nonoVNA which will arrive in a few days. I'm looking for advice concerning what to install on my laptop to use the device from the computer. Anything else I can do

Hello Al, Yes, the procedure that is created in that document is based on calibration of the 2 channel, port 0 and port 1, with the supplied coaxial cables. Yes, the calibration pieces are attached at

Try 3.5 e6

I have found it: https://hexandflex.com/2019/09/08/getting-started-with-the-nanovna-part-2/ And you have a part 3... Cheers! LL

Hello :) What about part 2? Cheers.