开云体育

Thanks Larry I try this based on your procedure at the wiki I used PuTTY (see attached pictures) However the issue remains. I wonder if there is a way to reset to factory default. Could reloading or

Where did you get the new firmware? Roger

Recalibrate the touchscreen.? On Sun, 6 Sep 2020 at 7:41 PM, Francisco Gonzalez<franciscoti5lx@...> wrote: Hello I just got a NanoVNA H. After I connected to the windows app the Menu

Yes, that does appear to be the case. I have a -H version and DFU'd the built-in firmware "1-of-11 H-LSI" and everything works well. The application's user interface makes DFU changes very easy via

When I go to calibrate sometimes some of the settings are already selected, "reverse videod". I suspect that when this happens that my calibration is not valid. What causes those settings to show up

Hello I just got a NanoVNA H. After I connected to the windows app the Menu doesnt work properly. Main menu shows up correctly but then you select any item the menu disapear. I meant the submenues

Do a search for baluns on the forum. On Sun, 6 Sep 2020 at 5:38 PM, mailscreen@...<mailscreen@...> wrote: I have not seen it addressed before but what is the best technique to

Vince, Place your Nano into dfu mode, connect the Nano to your PC, then in the device manager, delete the device AND driver that shows up. Next, right-click and search for new devices. Your Nano

I have not seen it addressed before but what is the best technique to interface the Nanovna with a 100R differential interface?

At message # 16998, OneOfEleven again provides access to your GitHub. There you will find your FW, which allows you to clear the configuration through the menu. You will also find the nanovna-app

Yea I saw that, I unfortunately can't connect to the unit in terminal mode to execute a clearconfig command. I can't see a com port for the device on windows 7 using the virtual drivers. It's sitting

I only got beeps to and no scanning on an older firmware release. Apparently OneOfeleven's program requires firmware that supports a newer data transfer mode. Roger

Sometimes after a firmware upgrade people do a Clearconfig 1234 Console command using a terminal program. This clears up some problems.... Roger

Hello, If your still interested, I might write some software to do this logging. It would be written in Keysight VEE and logged into MS Excel. I would prefer to take this outside the group. Let me

I took the case apart and it turns out there is a small frame molded into the top case that encircles the lcd. In my case that small frame was a bit too thick. So the solution was to take a dremel

You are a genius Larry. I grabbed the 2 halves of the case separately and put tension on them as if I was trying to pull them apart and voila, it works again. I should have thought of this as before

Yea I purchased better a calibration kit for it. The one that came with it had a load of 51.6 ohms (not terrible). The new kit is 50.3 ohms on the load. It seems to be reading something with nothing

Hi 1-11 Superb program.. the best I'v seen.. Very Nice Graphical and professional look... top functions, all we need Testing the 1.0.73 now on my NanoVNA Would it be connectable to NanoVNA-F ? or

It is an outstanding source for elder manuals from Tek, HP,...... larry

Sounds like you've got something pressing constantly on the touchscreen.? Remove the front cover over the LCD and see if the unit turns on ok.? On Sat, 5 Sep 2020 at 9:43 PM,