开云体育

Thank you,

I am running Python 3.6 with 32-bit Ubuntu 18.04 and it does direct Python interpret (not compiled) of nanoVNA-saver version 0.2.1 without problems, as best I can see. In playing with this, it appears

USB4 uses the same connector and is backward compatible. It is essentially a more open standard version of Thunderbolt 3, including that standard's USB compatibility and use of the USB-C connector.

I was a pretty early purchaser. The cable that came with mine has always been flakey. It's now become completely unusable. I finally went down to Target and bought a cheap replacement cable (I think

Hi Graeme Sorry to hear that you cannot get nvna-s working on LM19.3. Same setup works fine here. https://github.com/mihtjel/nanovna-saver At what point does this install process fail? What are the

Another problem with the demo board U.FL connectors is that they are surface mounted and unless you physically hold the connectors down while disconnecting cables can easily detach from the board.

I concur with these statements though I have managed to get the connectors mated but with some great effort and care. *Clyde K. Spencer*

You need a slit screw driver about 5 mm wide. Hold with one hand the female connector of the cable centric over the male plug on the board, and press with the other hand the female plug with the screw

Just be aware that the connectors used on the board are not made for repeated connect/disconnect and will not stand up to repeated connect/disconnect. Cables need soldering to prevent breakage .

Yes, those cheap U.FL plugs are a challenge to seat. I use SMA to U.FL adapters. Example is from Centric RF C9917B - Adapter U.FL/Plug S<A-Female (U.FL/AMC compatible) S Steel 6GHz VSWR 1.3 The

I have a question, from what I see. the problem seem to com from debian flavored distro. Anyone can report what version and linux distro they are using where NanoVNA-saver works right away? I am

Slightly better specs. Check the Wiki (link at bottom of every msg)

Hi friends , what is the difference between nano vna and nano vna -H....

Yes, we might even have got a newer version of python-pip3 - see below. Anyway, getting near to the bottom of this now. Following notes apply to LM19.3. As I understand it $ python3.7 -m pip install .

Look on the bright side - USB4 is on the way! :(

I bought one also and I cannot connect the cables either. Nice concept, but if it doesn't work, what good is it. Caveat Emptor 73, Dick, W1KSZ ________________________________ Sent: Thursday, January

When you mate these 2 items, do you use a BNC barrel adapter?

Herb I do use it with the test rig connected by cables and calibrate using good calibration standards with data from SDR-KITS that I got with my FA-VA5. Bob

That cable might be defective..

Hello Leif, NanoVNA-Saver does *not* use any image files in a zip-file - you must be thinking about NanoVNASharp, or one of the varieties. -- Rune / 5Q5R