开云体育

am i the only person with this issue?,as it stands its pretty unusable,at least for me thats the case!

@Gary O'Neil, N3GO - 2 December 2019 /g/nanovna-users/message/7680 Dear Gary, It is very nice, indeed, to hear from you again ! Well, regarding your specific request, allow us,

Hi pgc1682 Agree it is the better than nothing and that is what Rune said. To do any attempt to use literature form Keysight an try to implement such tools and utilize complex coaxial line models is

Bob - Please DO NOT apply 5 volts to the device if you have the battery connected directly to the power switch!! You WILL end up with a battery fire. The only reason the unit is working is because

I'm using ComTestSerial from microridge.com. The best of all, it free! :-) 73's de Karl LA3FY

I measure transmission loss by reading the display numbers when the marker is at the desired position.? If the line is open or shorted at the far end, the R reading in Ohms will indicate loss, as it

Erik,With the battery disconnected I connected 3.7 V to the off position of the power switch and it works. If I raise it to 5V and connect the battery, will it charge and operate on battery?? I would

Rune, I appreciate all the work you have done developing and sharing this program. Really looking forward to the next version of your program when you have fully implemented the "offset delay"

Thanks all for the sage advice, and yes, I do have some cheap dummy loads on order from Amazon - but darn it they only had overnight delivery for a shipping option - lol. So yes, my impatience

Thanks Oristo, That helps. Also, I found a couple of different ways to use the Fire as a monitor. A couple require paid for apps and a couple more use remote desktop software to do it. Going to give

From: hwalker Bruce, [] On the flip side, the cost of the NanoVNA is magnitudes below a commercial VNA so you can take a lot of liberties; however, its always a good idea to adhere to "best practices"

Yes I followed the installation procedure to the letter, the problem appears to be associated with Python3.7.4 not loading Pip correctly.

Simply a bad idea and in general a bad practice! Precision terminations in general are small low parasitic devices not designed to dissipate power. You do not mention the operating frequency but if HF

On Thu, Dec 5, 2019 at 07:18 AM, Bruce KX4AZ wrote: I am tempted to re-purpose the 50 ohm calibration piece from the OSL set as a "dummy load" when testing a low power (300 mW) RF transmitter. Does

And if it HF or even VHF- build your own. Dale W4OP

I think 0.3W may be critical for L calibration load. What is reason to try to use expensive precise calibration load as a high power dummy load, while you can buy cheap 5-10W dummy load on aliexpress?

I am tempted to re-purpose the 50 ohm calibration piece from the OSL set as a "dummy load" when testing a low power (300 mW) RF transmitter. Does anyone have any idea what the power dissipation limit

https://www.laptopmag.com/articles/how-to-sideload-apps-on-the-kindle-fire

I never thought about using a Fire as a larger display. Larry, you speak of "side loading" an app. Pardon an old dude but I don't know how to do that. Are there instructions somewhere on how to do

Hi Kurt Poulsen, I understand you, but something is false. Best way the fully calibrated instrument. But if not available, for example if can not do osl far end calibration port extension useful. This