开云体育

First of all apologize if I'm repeating the same question. But I browsed many messages to see howto buy, but lost in topics. I would like to buy Hugen version but could not able to manage buying from

cals and nvna-s cals. up the cables and do a device cal over that frequency range using an appropriate cal kit. I save that cal to say C0. same frequency range, same cables, same cal kit and save it

Especially if they are not properly terminated.

Do you remember those huge Fresnel lenses that used to be sold so you could 'enlarge' your 14" TV to 30" or more?? ?Maybe someone should design a 3d printed housing for the NanoVNA with a Fresnel

Larry, Thanks for the clarification. Too bad there isn't a similar 4 or 5 in display, although at that size I would think you would want more pixels instead of larger ones for better resolution. -

I made both versions. After communicating with edy555, I changed the nanovna label to nanovna-h label. You can check the nanovna-h label under the battery.

Herb, The slightly larger display that Herman installed is identical to the 2.8" it just has bigger pixels. The resolution and driver IC are the same as in the 2.8" LCD. Hence the direct swap.? On

Yes, but now you created another problem for the rest of us: you didn't post the link where you purchased the new chips from ?.?? Thanks for playing around with this until you solved it.??

This UmbrelaSmart app does recognise and display the NanoVNA usb info in DFU mode and it does perform a full erase. It might be the version number coded into the DFU file. I'm going to try playing

Herman, The 2.8 in display uses a 320 * 240 * 2 bytes to transfer data and I assume the 3.2 in display requires more. Therefore I am I right in also assuming that program features that depend on

After almost half a year of using my NanoVNA that did not want to start with the on / off, an old problem has been solved. After replacing the IP5303 earlier, my NanoVNA still did not start (the

I recently replaced my display with a 3.2 version that works with the same software (see the Wiki Files). Replacement with an even larger display is not possible without rewriting the firmware. And

Just as well; source includes comments like: "this is limited to stm32f405RG and will fail for other future chips." Well, it is newer than Android apps that I worked on, pre-Gradle and pre-IntelliJ

Yes, I checked it when I came home, I use different modes. But, the attenuators are on the way, so I can test more deep then now is possible. What a nice software, that's what I mean, with this

All network analyzers that I have worked on (repaired, calibrated and use nearly every work day) since 1977 (8409, 8505, 8753, 8510.......) have the test ports connected to and thru the same front

Zadig software simply ignores such misleading messages to install the >>correct<< driver, namely: right-click on DfuSeDemo icon, select "Open file location" * start in the Bin folder that has

Hello Rune, Unfortunately, quartz filters have a ripple. In the Attachment the plot of an IF quartz filter. One possibility might be to select rising and falling edges. Otherwise, I currently have no

Also I do not use the "jog" switch. I drag and drop the markers / and use all menu's by the touch screen. I also use a simple and very cheap PDA stylus. It makes life very easy and simple. 73 de Andy

Hello Rune, Unfortunately, quartz filters have a ripple. In the Attachment the plot of an IF quartz filter. One possibility might be to select rising and falling edges. Otherwise, I currently have no

This is part of the problem, then...I thought that AURSINC was not a clone, and not only bought one myself, but, when I found that it works well, I recommended it to others. It WOULD be nice to know