开云体育

Hello Larry, Adding the delay is not required and inappropriate. If the calibration kit is input to the VNA correctly, all C and L parasitic coefficients, offset delay and losses as defined by the

Hi colin.jaguar999 Sew the Clear Memory firmware first, and then the desired one.

Firmware for 75 Ohm "device" 12.10.2019

David, I did mention in the video at 1:43 showing a slide where the 85033D calibration loads produced the arcs that you and the manual mentions in chapter 5.? I then added electrical delay so viewers

*Only* authorized distributor? As in "no one else can distribute this item"? Authorized by who? edy655? If not then it seems a bit rich to me : - )

Yeah, I just discovered it :(Thanks for the quick update. On Fri, 11 Oct 2019 at 5:34 PM, DMR<bryonikater@...> wrote: Sorry, there was a small bug in the firmware. The corrected version is here.

Thank you. rs Sent from Outlook<http://aka.ms/weboutlook> ________________________________ Sent: Friday, October 11, 2019 5:48 PM To: [email protected] <[email protected]> Subject: Re:

Dick, The original developer of the nanoVNA asked that those selling the unit change the name to NanoVNA-H. So there all the devices selling in the $50 range are pretty my identical. The only variant

You may not have understood the idea I was trying to convey.? Most forum members know about placing D2 on the board to allow battery voltage monitoring.? I want to take it one step further. Since

Got mine from TaobaoFocus, mainly because it looks like in comes in a nice storage container and the device has a full cover, not just the pcbs. Assuming the pictures are right of course :)

Hi DMR I have just installed your amazing firmware! Works well, but when i press 'save' in the config area, and then switch off / on, it shows the version and hangs... Then need to re-install. Cheers

Where are folks buying this variant ? I see one on e-Pay for $50, shipped. Are there other sellers ? thanks, Dick, W1KSZ Sent from Outlook<http://aka.ms/weboutlook>

Ta.....

You gave two identical links. I looked at only the first. I don’t follow his logic. I think however he has failed to set up his 8753 properly for the calibration kit with the result he is fooling

--------------------------------------------------------------- The message from hugen that I linked to in my previous response provides that information. When you go to the GitHub page that he

I'm looking for either .dfu, .bin or .hex AA file.

Oristo, Good job maintaining your nanoVNA help page. I hope the following is not off topic. Under your "DMR-CLEAR_MEMORY_DFU.dfu" subsection on the firmware help page (

See: /g/nanovna-users/message/4630 - Herb

Double awesome DMR! Just ordered another NanoVNA-H and can't wait to try your firmware. - Herb

What is the latest AA firmware and where can I download it from? Paul