开云体育

I am not saying you should not post your negatives. I am just saying that is sounds very much that although you have a tiny SA you do not have a TinySA?. 73 -Jim NU0C "Peter E" <elekessy@...>

...since the returns are on the order of picoseconds. Light travels about 1 foot per NANOsecond in air, slower in coax. 73, Don N2VGU

I just downloaded NanoVNA-App and it is a great program.? No crashes and very configurable.Thanks for the tip. Bob, KN4HH

So have I! 'GROUPS' are great. -- Doug, K8RFT

Suggest you read the TinySA group for firmware updates and much more. /g/tinysa/ Have you seen: https://www.tinysa.org/wiki/ Cheers, David GM8ARV -- SatSignal Software - Quality

No, but if you blame it you should name it - show a picture of your worse little SA! And about which device do you talk actually, how much was it? Very confusing...

OK Jim, from now on I shall only wax lyrical about how marvelous and reliable these cheap VNA's and SA's are. I also won't mention that my H4 failed after less than a year (it definitely is a

For not having any issues you sure listed a lot of complaints. :) In re-reading what you wrote I will note that the TinySA/TinySA Ultra do not have a "Standby button". They have an old fashioned power

Roger, for my purposes, your jig is fantastic. Thamkyou. 73 Mike N7ATC

Hi Jim, I don't have any "issues". I was just replying to the original thread so others could make a more informed decision on whether to buy one or not... Cheers, Peter

It sounds like you do not have a genuine TinySA or TinySA Ultra. If you buy on eBay or Amazon you stand a good chance of getting junk clones. The TinySA products have overwhelmingly positive user

I have had problems with different versions of 5. Version 5 was done by a different developer and he has made quite a few changes to the code. There have been several reports of of 5 being "flakey"

Yup. I have the same issue. I open VNA View program, connect with that, then close that and VNA Saver will now load, connect and stay alive. Another guy said to pause scans on the nanoVNA before

Hi Roger, I have connected to it and even uploaded the firmware, and all seems to work OK. But when I turn the unit back on, just the normal screen with no sweep happening. Cheers, Peter - VK2AN

I also just downloaded V5.5 64 bit running on windows 10 and get the same results as previously reported. The Nanovna is discovered, it connects and a few seconds later shuts down. Bob W

It sounds like the Si5351 approach may indeed be advantageous over linear sweep via ramping a VCO if it allow interesting nonlinear sweeps to be experimented with (including solutions to range

I have just bought one of the 6Ghz ones I needed something to test the YIG in my faulty 6Ghz VNA, It was around AUD$300. They can be bought on Amazon and Ebay. Initial impressions - Cons- 1. I nearly

There is a nice review/write up and suggestions for future development of the low cost vna. This paper appears in the IEEE Microwave Magazine for this month of April, 2023. An excerpt here attached.

Try plugging it into a PC and see if it works with any of the Nano programs. Roger

Well guys, it appears that my Nano VNA H4 has permanently died. There is a screen display but no evidence of any signal or sweep happening. It did this once before a few weeks ago, and I fixed it by