开云体育

Anne, My knowledge and experience is limited, but SAVE 0 is loaded at power up each time. This is a good place to save the calibration data for the setup you use most often. Anything else you want to

If you were subscribed to it, you should stolii see its name in your subscribed groups, even if you can’t access it.

Rich, what is really puzzling - assuming that the original intent of father of "nanpXXXX" was to make money - why is internet full of "wannabe" experts publishing and mostly copying stuff with little

Id you can get dfu mode, then go into dfu mode and reload it. -- Sent from my Android device with K-9 Mail. Please excuse my brevity

Although this discussion is a bit old I thought I'd give it a try, mostly because my SAA-2N has the same page on Config view, 20200617 and 1a9a11d. While trying unsuccessfully to update the firmware,

Anne, since there appear to be several Facebook (FB) groups related to nanovnas, it is impossible, for me at least, to know which FB group you are, or were, using. The is no direct relationship

The following files and folders have been uploaded to the Files area of the [email protected] group. * /user manual and menu maps/nVNA-H4 v4.3_MS, firmware 1.1 User Manual 0102.zip (

I am in complete empathy with what I understand you to write. I was disheartened that so much time has passed with these devices on the market, and so little written by those who purport to be in the

Thanks Jim! Op di 7 jun. 2022 om 22:16 schreef Jim Lux <jim@...>:

On 6/7/22 1:14 PM, Jim Lux wrote: > On 6/7/22 10:30 AM, Victor Reijs wrote: >> In the meantime I found a document: >>

https://www.rfmentor.com/sites/default/files/NA_Error_Models_and_Cal_Methods.pdf "Network Analyzer Errro Models and Calibration Methods" by Doug Rytting of Agilent (at the time))

If I work really hard, and adjust the screws, I can fins a spot where the screen seems to work. But I still can’t get the control Knob to work at all. Is there an internal connector or ribbon

I have an H4 with latest DiSlord 1.2 firmware. But all of the SD card support firmware was done by DiSlord, and was introduced several versions ago - and it uses the same SPI interface on all of the

Stan: Which NanoVNA did you have and which software version? I assume this makes a difference regarding SD card compatibility?

In the meantime I found a document:

Figured this could use its own thread. https://www.convict.lu/pdf/ProdManualSDCardv1.9.pdf https://images-na.ssl-images-amazon.com/images/I/91tTtUMDM3L.pdf

You can use up to 32 GB. Finding out which cards are SPI compatible is another thing. You just have to search. Not sure how to find out for most. I tried to find out for SanDisk, and had no success.

I don't know of an easy way to see the SPI compatibility of a card. But these Patriot cards work (see photo). I purchased them inexpensively on Amazon.

1.6 SD CARD SNP files and screen images are saved with names VNA_yymmdd_hhmmss, and extensions of s1p, s2p, or bmp. Although it seems that the SD cards can be hot-swapped, the NanoVNA beta group

Which cards are proven to work with the NanoVNA-H? I don't want a collection of 16GB cards that don't work.