开云体育

Well, he asked for Gerber files. I have not found an inexpensive program that will produce Gerber files yet. ExpressPCB used to have a free program that would convert your ExpressPCB design to a

Indeed, you cannot draw a pcb layout with Ansoft Designer, but the required dimensions can be calculated in the designer. The program itself can be downloaded (DesignerSV050610, version 2010) from the

I agree too bad, that she has stopped developping.. such a top program hopefully in the future its like that in life... the good pay for the bad.. sad JP

To my knowledge, Ansoft Designer (no longer available) did not design pc boards or produce Gerber files. Zack *** If you are not part of the solution, then you are part of the precipitate. ***

While there are probably people on this list who can help with your question, you should probably address your question to the nanovna-f group at /g/nanovna-f. Having written that,

Okay. Here's my story: I recently returned a Nano H (the one with 4.0" screen) because although I bought a new one, the one sent was obviously used. In it's place I am awaiting delivery of a Nano-F

QUCS has stripline filter design and simulation capabilities. I haven't used them, but Youtube makes it look possible.

B.A. Schiffman, G.L. Matthaei, "Exact Design of Band-Stop Microwave Filters",/IEEE Transactions on Microwave Theory and Techniques/, January 1964, pp 6-15 They go through the whole cookbook procedure

Hi, I don't have OneOfEleven contact, that's why I write around here. I agree with the good people who enjoy the selfless work of OneOfEleven, that software is spectacular ! I have a Deepelec

Hi Ian, You must have a REALLY small screen for the stop icon to show up as an asterisk!? Have a look at the image for the button defs. Pressing the RECORD button toggles the saving of a single or

Hi Jim, If you want to know more than that, I recommend this link: http://www.gunthard-kraus.de/Ansoft%20Designer%20SV/English%20Tutorial%20Version/index_english.html 73, Gyula HA3HZ -- *** If you are

Thanks Chris! I'll take a look at building this up when I get back to my QTH. 73, Willie N1JBJ

Not sure if this'll help, but: https://hackaday.com/2016/03/23/michael-ossmann-makes-you-an-rf-design-hero/ KiCad apparently can do this... 73, Willie N1JBJ

Hi Larry, DiSlord et al, TCP/IP ... okay, I now understand its purpose. CW mode ... I didn't give signal frequency a thought. Signal Generator uses ... Asterick symbol ... looks to be a black square

Willie, sorry, it took me slightly longer than I thought, but now you can find the antenna part online: https://www.thingiverse.com/thing:4883218 Additionally, I wrote a detailed documentation about

I don't have microwave workbench software.? I need gerber files to make some PCB band stop/reject filters for Langmuir probes.? I assume shorting stubs are the best solution. The first PCB needs

Yes, I believe there is a Firmware update I'm going to try. Chris

I found nanovna server doesn't work on windows 10. It may be the same for nanovna partner... wrote:

Sorry to hear that a few have caused a big loss for so many people, Cathy did a big job !! Jos -- Dit e-mailbericht is gecontroleerd op virussen met Avast antivirussoftware.

Larry - Thanks for the help. The Blue charge LED on my NanoVNA-H4 only flashes when the voltage is very low (under 3.6 volts). When the charger is plugged in the LED stops flashing and goes to steady