开云体育

I hereby solicit further answers to this question, i e other people's takes on this issue. I did glean, from a joeqsmith video, that ideally one might leave two male-female cables permanently attached

Just for info, I am having difficulty getting the Python software to run the app. Same errors as other posters have mentioned. Upgrade Python on my Linux Mint and I appear to have all the correct

Karl, Have a look at a few of my earlier photos I uploaded. I used a thin 1100mAH battery from an old cellphone. The charging chip used on the Nano will charge almost any small LiIon battery. Do a

FWIW, given the overall construction quality, I'm going to repackage mine when I have some time. I intend putting a much larger battery in - perhaps something that will last 24 hours, so I just have

What is the max. physical size the battery can be to add to the Banggood model? Unlike a lot of other models, this one came without a battery, and I am looking for some advice as to what to buy. Do I

Output impedance can be calculated (estimated, at least) from the (complex) incremental change in output voltage and current after a small change in load impedance. No need to run anything open

you initially waved around a complaint which might as well be a surrealist's dream: your HT will be un-burnt when you fill your bathtub with brightly colored screwdrivers. and now you make rude

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* NanoVNA Calibration Considerations and

Hi Jeff, thanks for the shopping list :D I'll respond to each: 1) In the LogMag charts, each X-coordinate has a well-defined frequency. In the Smith charts, I would have to find the closest point of

Hi Bob, the app launches a console window first, in which any error messages should appear. If you double-click to launch, that's probably the brief flash you're seeing. You could try opening a

FYI - Following 75 Ohm version http://forum.vhfdx.ru/izmeritelnaya-apparatura/pribor-nanovna/msg369476/#msg369476

Very informative, thanks, this thread leads to a mention of a 1GHz commercial version with a 4.3" display (see below) which in turns leads to its firmware which seems to have been ported for a

Locking collar (or ring)? being the "loose nut" that holds things together.?? Semantics are important and I may have that terminology somewhat distorted. ?Wayne Maynard <wb6bfn@...>?

"rotating locking collar"? Is that as opposed to a "rotating only" collar? Den tors 5 sep. 2019 07:50Wayne <wb6bfn@...> skrev:

Is my "Unknown 1W source impedance calculation" theoretically correct? -Please ignore real measurement problems below- * My measurement gear still poor * Mismatch reflection happens front of -60dB

Some calibration standards do not have a rotating locking collar. In that case there is no way to avoid rotating the center pin unless you use those very short male-female SMA adapters sometimes

Try as I might, I cannot keep the pin+back assembly still while screwing the short and/or load calibration piece down in the SMA socket! Should I add some grip to their backs, with glue or solder?

Why you guys talking about 'YOUR HT IS SHIT' or 'BURNT? THIS IS NOT IMPEDANCE ISSUE', 'ANTENNA WILL DAMAGE' or WORRYING ABOUT MY VNA?( I am not stupid, I know right way to connect LNA) Please stop to

I just did a fresh git pull and did a compile with GCC V8 update 3. It worked fine, no issues with SRAM space.

That is a very nice Idea, I would buy a second one for such work. There is also the path of going to a raspberry Pi that could drive a screen and just grab the raw data for the calculation In fact a