开云体育

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* NanoVNA Calibration Considerations and

Hi Jeff, thanks for the shopping list :D I'll respond to each: 1) In the LogMag charts, each X-coordinate has a well-defined frequency. In the Smith charts, I would have to find the closest point of

Hi Bob, the app launches a console window first, in which any error messages should appear. If you double-click to launch, that's probably the brief flash you're seeing. You could try opening a

FYI - Following 75 Ohm version http://forum.vhfdx.ru/izmeritelnaya-apparatura/pribor-nanovna/msg369476/#msg369476

Very informative, thanks, this thread leads to a mention of a 1GHz commercial version with a 4.3" display (see below) which in turns leads to its firmware which seems to have been ported for a

Locking collar (or ring)? being the "loose nut" that holds things together.?? Semantics are important and I may have that terminology somewhat distorted. ?Wayne Maynard <wb6bfn@...>?

"rotating locking collar"? Is that as opposed to a "rotating only" collar? Den tors 5 sep. 2019 07:50Wayne <wb6bfn@...> skrev:

Is my "Unknown 1W source impedance calculation" theoretically correct? -Please ignore real measurement problems below- * My measurement gear still poor * Mismatch reflection happens front of -60dB

Some calibration standards do not have a rotating locking collar. In that case there is no way to avoid rotating the center pin unless you use those very short male-female SMA adapters sometimes

Try as I might, I cannot keep the pin+back assembly still while screwing the short and/or load calibration piece down in the SMA socket! Should I add some grip to their backs, with glue or solder?

Why you guys talking about 'YOUR HT IS SHIT' or 'BURNT? THIS IS NOT IMPEDANCE ISSUE', 'ANTENNA WILL DAMAGE' or WORRYING ABOUT MY VNA?( I am not stupid, I know right way to connect LNA) Please stop to

I just did a fresh git pull and did a compile with GCC V8 update 3. It worked fine, no issues with SRAM space.

That is a very nice Idea, I would buy a second one for such work. There is also the path of going to a raspberry Pi that could drive a screen and just grab the raw data for the calculation In fact a

Hi Rune -- 0.0.5: Works nicely for me! Good stuff Rune!!! I like it better than any of the other apps I've seen for the nanoVNA. 73 -- Harry, W5PNY

I think many of us would really like having built-in TDR functionality for simple antenna & feedline testing.?? Considering how inexpensive the nanoVNA is I, for one, would not mind having one with

Actually, I should have said appeared in the window (app is a bit ambiguous). And I just wanted to add -- overall this is a very impressive app. I love it! - Jeff, k6jca

Hi Rune, I have downloaded your release 0.0.5 and am checking it out. Some comments: 1. At first I thought the Mouse Cursor was broken -- I was clicking in the S11 Smith Chart plot and I wasn't seeing

the hype seems entirely misleading to me. the typical basic rubber ducky is quite robust, i agree. however, higher gain multiband aftermarket antennas may well not be as robust. - 67 (base 11) -

I too have tried to execute the .exe file from the .zip window, I am running Windows 10 64bit version and get a dialog box that I say to run anyway, but only get a brief "flash" window on my screen

Found! Thanks again.