开云体育

Oohh. that's everyone's first guess.. but think about it.. if you want to measure the S11 of a LNA, you can't put 50dB of attenuation in front of it. You put 50 dB of attenuation in the stimulus line,

There was an application note written for the SARK-110 VNA on measuring traps. The setup details on the analyzer are different but the method is the same....

Eric, if DeFuSe demomshows your device is in dfu mode, your driver's are working. Make sure you're using the Upgrade (Flash) button and not the Upload (read device flash) function.? If you used

I would think attenuators and booster amps may as well be in the external cables. Not terribly familiar with all this, perhaps there are special tricks involved to measure something like s12 on an

yes, it's going towards the fieldfox type of capability, not the "bench VNA" - The latter would typically bring out the source and receiver inputs with a loop, so you could use different bridge or

I would probably test a parallel tuned trap as a single port, with the far end of the trap grounded. Should see the impedance head towards zero at the resonant frequency. But could also be done as a 2

That's a beautiful looking board layout, clearly done by somebody who knows microwave RF. If the spec's are anything like those stated, I'll probably buy one eventually. Whatever final form it takes.

Hope DisLord gets an engineering sample?

Only connect SWDIO, SWCLK and GND. NRST is not needed. Neither is VDD If needed force nanoVNA in DFU mode by connecting BOOT0 and VDD before switching on. -- NanoVNA Wiki:

I also interested in "engineering sample" with or without milled enclosure? Pada Selasa, 29 September 2020 18.12.10 WIB, Carsten Bormann <cabocabo@...> menulis: It is probably a quite limited

Indeed - if there were a decent python+libraries on Android, it would be straightforward to move NanoVNA-Saver as a start. If you were *bold* - Java is sort of the native Android language, but I don't

Here's a nice article on measuring components with a VNA, discussing the three test configurations - fixturing, error analysis, etc.

Hello all... I'm new to VNA's, and need some guidance. What is the way to connect my NanoVNA-H to a dipole antenna trap so I can tune it, and read resonant frequency, Q, impedance, etc.? Thank you for

Here they are, fresh from nanovnasaver after SOLTI calibration : NanoVna has been boxed with a pair of SMA to N adapters. 73 Federico ik3umt

Thank's Klaus. Indeed, when I notice an update, I make changes here as well. -- *** If you are not part of the solution, then you are the problem. ( http://ha3hz.hu/ ) ***

Post the graphs or the S21 files from NanoVNA Saver.

That boom cost includes the milled aluminium enclosure? If so, that is a very good price. If available I would be interested in purchasing an engineering sample, without the case. I suspect that

It is probably a quite limited amount of work to port the PC software to Android. Then simply sell a bundle of a cheap Android tablet (these are cheaper than the screens inside them :-) and the

Hi, new to this group. NanoVna ttrftech v. 0.5.4 NanoVnaSaver v. 0.3.7 I'm trying to use a home made fixture for testing chokes via S21 parameters, two short wires exiting VNA ports ending with clips

Yes, connection some. But in my firmware you can select current connection type (USB or Serial), speed in menu in any time. Can configure module from NanoVNA console. Can connect different device and