开云体育

I have not seen it addressed before but what is the best technique to interface the Nanovna with a 100R differential interface?

At message # 16998, OneOfEleven again provides access to your GitHub. There you will find your FW, which allows you to clear the configuration through the menu. You will also find the nanovna-app

Yea I saw that, I unfortunately can't connect to the unit in terminal mode to execute a clearconfig command. I can't see a com port for the device on windows 7 using the virtual drivers. It's sitting

I only got beeps to and no scanning on an older firmware release. Apparently OneOfeleven's program requires firmware that supports a newer data transfer mode. Roger

Sometimes after a firmware upgrade people do a Clearconfig 1234 Console command using a terminal program. This clears up some problems.... Roger

Hello, If your still interested, I might write some software to do this logging. It would be written in Keysight VEE and logged into MS Excel. I would prefer to take this outside the group. Let me

I took the case apart and it turns out there is a small frame molded into the top case that encircles the lcd. In my case that small frame was a bit too thick. So the solution was to take a dremel

You are a genius Larry. I grabbed the 2 halves of the case separately and put tension on them as if I was trying to pull them apart and voila, it works again. I should have thought of this as before I

Yea I purchased better a calibration kit for it. The one that came with it had a load of 51.6 ohms (not terrible). The new kit is 50.3 ohms on the load. It seems to be reading something with nothing

Hi 1-11 Superb program.. the best I'v seen.. Very Nice Graphical and professional look... top functions, all we need Testing the 1.0.73 now on my NanoVNA Would it be connectable to NanoVNA-F ? or the

It is an outstanding source for elder manuals from Tek, HP,...... larry

Sounds like you've got something pressing constantly on the touchscreen.? Remove the front cover over the LCD and see if the unit turns on ok.? On Sat, 5 Sep 2020 at 9:43 PM, diyer<m240zz@...>

The smith chart shows around the centre but you've got nothing connected to port 0. It should be at the right side if port 0 is open?? Are you sure your 50 ohm calibration part is good? On Sat, 5

Is there such a thing as a hard reset? A real switch somewhere, not the screen? Maybe remove battery and reinstall? My nanovna-h with ver 0.4.5-1 gfbbceca was working ok, occasional hang but on off

Hi Larry, Yea that’s the first thing I did. Ran through it a couple of times. The screen calibration seems to be a little wonky now too.

That should be a stable release. Did you press the Reset menu button immediately before calibration? On Sat, 5 Sep 2020 at 8:40 PM, Vince Rooney<vince@...> wrote: Good Evening Everyone, I

Good Evening Everyone, I just uploaded the latest release from 6-19-2020 (2020-06-19T23:08:21.000Z 9f940ce 202) and the traces are jumping all over the place. I tried recalibrating it and it didn't

In that respect, who remembers the articulated test ports for use with the 8510 VNA (now lusted after, discontinued, but still expensive - originally over $100k). Those were EXPENSIVE "cables"!!!!!!

Clearly the negative real part in this case is in error. As has been pointed out, calibration error is a very likely culprit. Here's one form of calibration error that does not seem to be widely

I not see any reason use in SAA2 1024 not calibrated point mode for CPU send (this need a lot of ram) I test speed on H4 (on V2 result should be some) (thanks OneOfEleven for add points/sec measure):