开云体育

The soil conductivity and permittivity change with frequency and over a very small area. Rudy Sevens wrote a paper on how to model a low dipole over ground and then change the ground characteristics

Great, now you can set minimum and maximum in SWR, now it works. There are also many markers, more than three. It is perfectly. I only use this program. it is very stable, I would say, it works for me

John, Thanks. Nice to read that it is possible what I was looking for. Sure. I discovered that it is possible to position the reference point not only on the gridlines, but also between them. However

Yes. Finger tight leaves small gaps around the fittings which act as HF cavities. The material has to be stressed into plastic deformation, which limits the number of installs to ten times for one

As a mechanical engineer I have known about torque wrenches for years There have been studies of their accuracy and it can be said that overall it is generally +/- 50 percent. There are several

Usually, yes! RF connectors that are insufficiently tightened usually work loose with even trivial handling, leading to poor (and intermittent) shielding integrity, mysterious resonance dips that come

This offer is just for the USA. The rest of the world can buy for a similar price from: THGS Mxita SMA drehmomentschlüssel RF stecker ?ffnung 8MM https://de.aliexpress.com/item/32972795189.html It

Is anything more than finger tight really necessary? Aldo W2AGC

Hi I am new to the Nanovna and I apologise if this question has be asked before. I want to measure soil conductivity and relative permittivity. Are there standard electrode dimensions and positioning?

Hello group, I found this 8mm torque wrench on eBay: https://www.ebay.com/itm/402050311301 It is factory preset for 0.59N-m which is just below the upper limit for brass SMA connectors. It seems to do

Can someone please send me the link to the Windows 10 64 bit Nano Saver 0.3.6 EXE file? Thanks *Clyde K. Spencer* lu8eff@...> wrote:

Anne, with your great sense of humor this will only be a minor setback. From someone who can usually find their hammer. Good luck! Allen KI4QCK

I've re-enabled SD card Igor, though this is the compile without the external 32k xtal enabled - for now. I've not yet added the dual graph DMR wants, but will get there. I've done a lot of other

The answer is in the WIKI, see the link below in your mail. A lot of answers are there. Kind regards, Arie Op 20-7-2020 om 17:16 schreef Lawrance A. Schneider:

Larry, I'd start with the wiki: /g/nanovna-users/wiki 73! Mark KA6WKE Latest Video: https://ka6wke.net/gmail Website: https://www.ka6wke.net llaassllaaass@...> wrote:

Hello, I have asked a number of individuals separately and received no replies. I keep reading about new software, new firmware, new external options, new screen sizes, ..... BUT, what is the basic

If this is a H4 model the plastic case overhangs the USB port and should be removed and filed down. If the stuck USB plug is with the H model I would dispose of the cable. The USB cable that was

Thanks for replies. Luckily I do not have a case , and that is the only reason I need to unplug it so I can build one. The USB C connector went in with noticeable click. Anne PS Not to worry , I

If it did save 6k of flash, I'd be able to add a proper small (minor flash size usage) spline interpolation routine that would be far better than linear interpolation, so I'll look at that then at

I can suggest one thing (want test result, but not found time for it): in code sin and cos functions used only in If you remove this use - it allow save ~6-7k flash. sin cos functions use big size