开云体育

Hi Anne, Use some pliers, but be very careful...... Officially you have to use a special tool with controlled torque. Jos Op 19-7-2020 om 17:42 schreef Anne Ranch:

Hello, new user here. After my new NanoVNA passed "out of box" check I need to unplug the USB connector. It won't budge. Should I get a bigger hammer? Anne

Fixed scan_bin byte order, now proper little endian.

ps .: copy the link in the message in its entirety so that you can download it. You cannot download it by clicking on it. -- *** If you are not part of the solution, then you are the problem. (

Hi Joe Joncas, You can also use the latest (v0.3.6) version of nanoVNA-Saver on your Windows 32-bit machine if you run it under Python. To do this, you need to install Python on Windows. Description

Take a fine needle and gently bend the center connections on the SMA jack back together,

Added a new serial command to fetch the scan data in raw binary format rather than inefficient text based stream .. helps speed up the serial transfer rate for PC software scan updates. usage:

Super Glue has great strength and one Weakness. I use a lot of Superglue when I turn bowls. I buy it by the pint. Superglue will not take a shear force well. I have released a temporary glue joint,

Hello Group; I have been having random problems with the front case touching the display and causing odd results. Yesterday I found a good solution, which may be of intrerest to many. I noticed that

Gary, You cannot brick your Nanovna even if you load the wrong FW as the bootloader is in a normally non-writable area, not flash.? I've intentionally corrupted the FW in my unit to verify this.?

If you have H version, open nanoVNA, search Connect in together and power on nanoVNA, after possible upload new firmware as before Remove this connection after finish On H4, possible push leveler

Hi Enrique, NanoVNA-Saver 3.6 runs well on Windows 10 64 bit, at least for me, you can download it here : https://github.com/NanoVNA-Saver/nanovna-saver/releases Jos

An easy to prove possible cause: It could well be a contact (or less probably a PCB jack solder) problem. Try to rescrew the plugs or gently rock them a bit. The SMA cal Load received together with my

Well, several things come to mind. First, did anything of note happen "yesterday" ? It is pretty easy to burn out the port if you accidentally tr

Checking before calibration is not reliable. Put it in the freezer for a few minutes and see if it works again until it warms up. Gary AG7TH

Hello everyone, I have a nano VNA that is now refusing to read correctly after calibration it seems. After running a one port calibration using the calibration assistant, using the supplied open,

Before I screw up my Nano, I was wanting to know if you load the wrong version of FW into say H4 that was written for the H, first can you, and if so can you reverse it back to the correct FW? Gary

Reg, All of DiSlord's firmware for the H4 supports 50, 101 and 201 points. He uploaded his last release a few days ago - search his name and you'll find it. It also has a nicer menu now.? ... Larry

Hi Enrique, NanoVNA-Saver 3.6 runs well on Windows 10 64 bit, at least for me, you can download it here : https://github.com/NanoVNA-Saver/nanovna-saver/releases Jos Op 15-7-2020 om 01:52 schreef

I've got a black 2.8" clone and a recent Hugen H-4 from R&L Electronics. I suspect that the STM32F103 version can't do more than 101 points except via a PC, but it seems to me the STM32F303 version