开云体育

I would have followed up by contacting Rig Expert directly or? via the appropriate RigExpert forum. This NanoVNA group has nothing to do with RigExpert hardware. Mike N2MS At a practical level, it is

I grew up in a restaurant, so I used dining room tables to play. We literally didn't have a "kitchen table" in our house. I slept in the dining room. And was more interested in fireworks than

Mike, As stated on the website, I contacted the supplier (RadioWorld) who were most unhelpful. I didn’t list their comments on the website, but they were unhelpful. A guy from RadioWorld telephoned

Dave, If i could cause damage did you open a support ticket with RigExpert, notify them of this defect or request a replacement unit? Mike N2MS

I am not surprised at all Zack. However, in the case of * This particular RigExpert AA-600 * A good quality calibration standard damage would result because the N connector on the particular sample I

I upload all my releases to /g/nanovna-users/files/Dislord%27s%20Nanovna%20-H%20Firmware SD card support not compleded, all beta for test you can find in this thread (but my main

The RigExpert manual describes how to perform an open/short/load calibration standards, but *states that good quality standards must be used. * However, if the particular unit we have was mated with a

I have used at least 10 different N connectors, including commercially-made N to other type connector adaptors, and elbows, onto my AA-600. I have never had a problem or damage to the center cotor on

wrote: No, the lack of a gasket is not a problem - you will never find one on any calibration standard. They are generally more of a nuisance than useful in a lab - I remove them. They just trap the

Sorry but what products does Dave Kirby sell which compete with the AA600? Perhaps I've missed something.

Vidas, The rubber gasket does not normally set the pin insertion depth, that is controlled by metal-to-metal contact of the outer conductor. However, if the rubber seal is present it can be hard to

Dear OM, Do not know why you use of the word "we", from what it looks its just you. In any case, I'm not here to discuss this with you and I do not know why you jumped in. I just hope that DiSlord

I see you didn't expect an answer from me. Successful source search. We will be happy to use the product without knowing how it is made.

I learned half of what electronics is about on my parents' kitchen table ... i had to remove everything to eat !! The nanovna is a wonderful machine but it can overwhelm a beginner due to its great

Hi Gyula, Of course and seen it. I'd expect though the usual approach that others do to be taken by DiSlord too. Since he himself also forked the code from another opensource repository, to place the

A little more understandable if you could. The starting point of the topic is that nanoVna-H can also be used with this AntScope2. Many of us claim that it doesn’t work for us. I can see that so far

To the moderators or group owner,?Perhaps it's time "Dr Dave" stop advertising his title, company and products here,? ?now even nocking other and competitive products here?are just not

And why would you push? your Connector analysis, showing massive 0.003" discrepancy, down our throuts? on this NanoVNA group??(I personally have the AA-600 and it is, a great product)

According to them, the nanovna works on 2.8 ", as its makers said. For me, Ms VC ++ is installed, when installing AntScope, it rejects the version integrated in the installer and does not install it

There is a vendor on Etsy that has cases for the original nanovna. Gary, K7VBY