开云体育

Hi Salil Found one, however LiPo but I believe is will work as well as Li-ion

Hi Salil I ordered one too, and are now searching for a Li-ion battery 1000-2000mAh max dimension 6x40x60mm preferably with JST-XH 2.54mm connector. Have you found any ? Kind regards Kurt

Both the original nanoVNA and the V2 fit perfect in the 100x60x25mm box you can find very cheap on eBay. Example: 5 for 4 Euro

Same here. This isn't the device I was hoping for it to be. -- John AE5X https://ae5x.blogspot.com/

Hi, I tried rasberry zero wh with nanovna. No succes. I use Raspbian. Graphical user interface very slow, without nanovna. I try command line only mode and rtl_sdr tcp server. Extreme slow, simply not

From: zl2arl https://www.tindie.com/products/hcxqsgroup/nanovna-v2/ ============================ More sweep points, excellent! Greater frequency range, good but why no 10 kHz? However, low cost has

Sadly, after I installed it, all I get is a badly twitching display. Can you tell who to turn to for fixing that ? ________________________________ Sent: March 6, 2020 6:11 PM To:

Check this group's Wiki for more information on this program (and lots of other NanoVNA material) . There is a getting started guide. Roger

WOW !!!!! Thanks Roger. What a wonderful program !!! Never heard of it. ________________________________ Sent: March 6, 2020 3:59 PM To: [email protected] <[email protected]> Subject: Re:

I suggest you use the PC program NanoVNA Saver because it has several different display panels. One is R+jX which will give you the Resistance (which will rise with frequency due to the skin effect)

Hi, Now, I have good succes Nanovna WIFI mode with Android phone (Samsung Xcover 3). Nanovna connected to phone with USB-OTG cable. This phone not new, Android 5.1.1. I use on phone TCPUART by

Hi, I tried rasberry zero wh with nanovna. No succes. I use Raspbian. Graphical user interface very slow, without nanovna. I try command line only mode and rtl_sdr tcp server. Extreme slow, simply not

First use the appropriate equation to solve for the diameter or number of turns etc for the desired coil. Toroid, solenoid...? Then do a one port CH0 cal on your vna from 1 MHz to 100 MHz only. That

https://www.tindie.com/products/hcxqsgroup/nanovna-v2/

I have to wind a 100 nanoHenry inductor. Can anyone suggest a methodology for using my H4 to measure it ? I do have a 100 MHZ scope but not an RF generator for the intended 137 MHZ operation. Thanks.

Its available on Tindie. Just order two from there instead of going through the SZ seller I was planning earlier. -- Salil Tembe (Nuclearrambo.com)

Does performance depend on or require electrical contact from the adjustable supports? -- I_B_Nbridgema

Well, I upgraded my Mac OS X to 10.14.6 yesterday, and without doing anything else, nanovna-saver v 0.2.0 (which I had installed last fall, but would not launch due to a PyQt5 compatibility issue with

Oops: Can this be confirmed?? Is it a REAL H4? Hit SEND too soon...

Doug, Can this be confirmed it is a REAL H4? 73 Glen K4KV