开云体育

Hello David, I mentioned in a much earlier post, I have no idea what is in the firmware definition for the standards supplied with the nanoVNA. In addition, based on the physical description of the

And with battery upgrade. My unit doesn't have a built in battery, so I found one, for now works... but pretend to update the connections and the battery itself, this one is a "little" big for the

no attachements...

[email protected]> wrote: I don’t see any attachments! Dave, G8WRB -- Dr. David Kirkby,

What exactly do you mean by that? Are you saying that the firmware has the ability to allow one to adjust the delay of the calibration standards? If so that’s good news. Just being able to enter a

Yes, calibration data can only be modified with electrical delay. For better accuracy, I customized the shortest and most accurate calibrations kits possible. Naturally, the accuracy of professional

Hi George, I scarfed the commands by going through main.c (and a few posts here) and there is some ambiguity on how to format a few of them as well as how executing some might affect others. If you

Some photos of my NanoVNA measuring a "6.5MHz" Butterworth LP

Hi Larry, The NanoVNA command listing you posted is all that is needed to communicate with the NanoVNA. I am writing an article on the NanoVNA as well as writing software to perform all the

David, Refer to my initial posting (a few posts back from this one) of the NanoVNA Console command listing as well as the Python sourcecode just mentioned. That should be more than enough info to

Hi David, The simplest way is to read the Python source code example. 9600 bauds seems to be a right choice for USB communication speed. Regards, David, F4HTQ.

This is somewhat prompted by a recent question about PC application function/capabilities. Is the (USB Communications) messaging between the nanovna unit and the host PC - 1. Documented? 2. Could be

NOTE: I created this list by reviewing the older Github source code. This is the first iteration and there WILL be mistakes - but it's a starting point for the documentation of the console

Dave, as far as I can tell to this point, there is no ability to enter your own polynomial coefficient of the standards. The unit comes with SOL 3.5 mm and they are described as fairly simple

I've got nanoVNA on order, but don't have it yet. It's not due to at least 4th July, so that's no big surprise. Can anyone tell me if one can change the coefficients of the open/short/load kit? I

Alan, Thanks for message 83. I will try that this morning. Bill

Thank you! The photos are a great help! Bill

See message #83. Alan

Bill, I wrote up a calibration sequence in an earlier thread. If you cannot find it, I will cut and paste in a reply. Currently this was done on the 2 -track unit but I assume the sequence is no

SMA male calibration kit (OPEN / SHORT /LOAD).