开云体育

Small request---I do. not see anywhere a way to save colour changes e.g. in background on graphs or foreground lines, it would be nice to save one's own preferences ???? Jrd VE7QJD

Not split, zplot!? Stupid auto spelling correction :-( On Sat, 7 Dec 2019 at 6:57 AM, Larry Rothman<nlroth@...> wrote: Lajos, Try using the Split with?SoftMaker Office?, free version. They

Lajos, Try using the Split with?SoftMaker Office?, free version. They claim that it will accept anything written for MS Office. There are versions of?SoftMaker Office? for Win, Linux and Mac but I

When attempting to install and run nanovna-saver on my old win-7 laptop, there were two specifically related problems: 1. missing: api-ms-win-core-timezone-I1-1-0.dll 2. missing: Microsoft VC++

The picture below shows the ST-Link V2 connector to be routed to a pin row. When you use it with one of your fingers, you gently press it when you are programming. No need to solder. This was the

Hi Kurt and Erik, Thanks for many comments, tests. Of course Nanovna is very great. Pierce/value is very good. Support from developers and from users also very good. I think nanovna-saver for expert

Correct link here: /g/nanovna-users/attachment/5917/0/Male%20and%20female%20calibration%20NanoVNA-H.pdf

the calibration is fine,it works with the is it sharp vna fine just not the saver one

Hi Eric and Ady There is also the lazy way if you know what type of cable you have between equipment and the antenna Use a time domain method to find the cable length (You need to know the cable VF)

Hi pgc1683 (do you have a name or are you an alient ?) I have repeated the measurement for sending you some s1p files. I have also made a report where the measurement are seen and exposed to ZPlot.

Thank you!? I will inspect my unit and if it's similar, I will order the LINK. Bob For completeness? (from https://je6lve.tom-system.com/archives/1066): nanoVNA <——–> ST-LINKV2 SWDIO

A super big thank you to all involved for the manual. Very special thanks to cho45 and Larry !!! 73, Hans DJ7BA Von: [email protected] <[email protected]> Im Auftrag von

For completeness (from https://je6lve.tom-system.com/archives/1066): nanoVNA <——–> ST-LINKV2 SWDIO <———-> ②SWDIO SWCLK <———-> ④SWCLK GND <—————> ⑥GND NRST

Larry, I will check to see if my board is like that.? If so, I can get the ST-LINK and have a fully working unit.? If not, no big deal. Thanks for your efforts and patience; you have been a great

Bob - P2 is at the edge of the PCB and can only be used with the ST-Link dongle.

Where is P2?? Which connections go where?? I have removed the USB socket and can't figure how to get it back. Bob

Bob, have a look at this photo: /g/nanovna-users/photo/0/974?p=Created,,,20,2,960,0 You're connecting the ST-Link to P2 on the edge of the Nano's PCB. You can pick up the ST-link

Larry, I don't see how to attach the ST-link but for $2 it might be a solution.? Can you provide more info? As for Aliexpress I have been having serious trouble with them.? The latest involves a

As yet I've had no issue with the current USB connector used... but its small and fragile. On another piece of gear I've had issues with the mini and micro USB connectors and finally removed it with

Fixed the url