开云体育

Hello all, I was going to place an order for the NanoVNA-F today and the link that I have for the BH5HNU version is down. I would like to buy from a reputable source and I know that huygen is the

#78: on the measurement of s-parameters using the [LeastVNA] only - 12 November 2019 - /g/nanovna-users/message/6912 - Hello, Allow us, please, to inform you that we just uploaded the

450mAh is... Not suitable for NanoVNA 1. Stand-by draw 2. Charge circuit pushes over 1A( over 2C rate ) My battery already swelled( PCB/LCD curved slightly )

Fine under Ubuntu 19.10 and Mate desktop. Also never could get it to run under XFCE4.

On my Mint system there was a 3.7 lite package that would install alongside 3.6 and leave? 3.6 as the default version.? nanoVNA-saver worked fine with that package and it didn't mess up other python

Works fine here on Linux Mint 19.2 amd64 with python 3.7 per instructions here... https://github.com/mihtjel/nanovna-saver Note nvna-s requires python 3.7. Not earlier versions. Looks like some good

Doesn't work on my Linux Mint 18.3 cinnamon with Python 3.6. Python has to be updated to 3.7. I tried that before, but other apps stopped working then. So I rolled back to 3.6 Carsten

This is the VNA I am working on. It has the EU1KY bridge (based on a RF choke) and not the divider bridge. Among its advantages is that it directly samples the IF signal on the clock so that a high

The most recent version of nanoVNA-saver runs fine on Linux Mint 19.1 Cinnamon.? Most development tools are available for everyone.

There is another way to skin the cat so to speak and measure these non resonate high (or low) Z antenna. That is to say an antenna not near 50 ohms. Consider going through the effort of constructing a

Hi Oristo My comment regarding about "waste of time" regarding S21 measurements was solely based on how to save a S21 sweep and convert it from transmission to reflection. There are other option which

I am using it on Linux Mint Cinnamon 19.1 NanoVNA version 0.2.0 and it works fine. Dave N2VUZ

Hi Andy - The W0QE paper indicates that, seemingly because of errors introduced by parabolic curve fitting in AIM4170 software, calibrating with higher impedance yielded results that he liked better.

I am using Linux Mint Tina and it works well.

Hi Kurt - Thanks as always for your expertise and patience for explaining VNA best practices! This second paper motivates mastering T adapter techniques, particularly for low impedances.

I am looking for help to try and fix this problem, My Linux computer complaint is : Could not load the Qt platform plugin "xcb" in "" even though it was found. Indications are this is a library

If you can lay your hands on some of the old General Radio (GR) connectors, they would work well. Finding them will be the challenge. Dave - W?LEV

Hi Oristo It is a difficult task to measure highZ components based on two restrictions. For the first the DUT used to test the VNA test set up is it really a HighZ with flat response over a large

This discussion answers many "who is on first" questions. Some of them I had posted on my first post and received some answers too. I have been reading the mail ever since that first post and have

no, it doesn't work because it requires Android 7+ -- *73, Lucio I0LYL Rome, Italy*