开云体育

As long as there are no unwanted SMA connectors, I don't want to stick my nose in their personal affairs. ;-) ~R~ 72/73 de Rich NE1EE The Dusty Key On the banks of the Piscataqua

..and looking to orient myself. Have a NanoVNA H as well as a NanoVNA H4 but this query is about the "H" only. I flashed the firmware with a DiSlord clone (v1.1.01 (Build Dec 30 2021) after having

I replied to your post on this issue a few days ago but you did not reply. Did you see my post? /g/nanovna-users/topic/91082901#28066 Roger

Saver defaults to 101 points to maintain compatibility with older NanoVNA devices. I just go into Manage and set it to 401 points. Seems to work fine for me. What version of H4 firmware are you

Yes, saver has some bugs. In particular I have noted some inconsistencies when trying to set it for 401 pts on the H4 (it works better if I let it use 201 or 101 pts and then let Saver control

Hi I have this hardware on this attached photo. All seems running as expected except for the touchescreen , it's arratic . i tryed to calibrate it , test function still showing erratic behavior

Maybe it's not the way to go for your use case. Have you tried editing the .ini file? >

That's just wrong. Every time it connects, it reset the H4 to what someone else thinks it should be. The user should be the one to determine that. I even changed the Manage settings to agree with my

+1

clean socket AND plug!! dg9bfc sigi Am 15.05.2022 um 16:51 schrieb Zack Widup:

I use a Q-tip dipped in alcohol to remove the particles that accumulate inside a female SMA connector. As for deformity in the center conductor, I don't think there's much you can do for that. Zack

Electrical tape as a 'condom'. Put them in separate places could control mating. -- KT0TT Allen Kiddoo

I did download, and will use it on my next tests. Thanks also for the writeup. It is very useful to keep in mind when using Saver. I think that I must start and connect nVNA to PC start

The initial releases of NanoVNA Saver were developed by Rune B. Broberg for the NanoVNA-H and nanoVNA-H4. Unfortunately he became ill and development stopped at version 2. Further development of V3

Rich, From your reference links it looks like the "offset delay" should be entered as a positive number representing the one way delay through the port extension. I have modified my fork of NanoVNA

yes ... a short male to female adaptor is a good advice to keep the built-in connectors in good shape ... if worn out just replace :-) i use a similar thing on my rf explorer (also sma

Please take all of the following bearing in mind that I am a VNA novice...it is nice to have this perspective on the table. I intend to search the forum for the threads mentioned... I actually don't

When the author of NanoVNA saver implemented "offset delay" it was discussed in this group. The consensus was that it should be in accordance with the standard definitions used for calibration kit

The # of mating cycles for a NanoVNA will be much lower than that of commercial grade connectors for several reasons. - Low-cost Asian connectors are used to keep the cost down - Users often rotate

I don't think that we are using the same device! :-) 1. The MODE button shows what IS selected, not what WILL BE selected. 2. TRANSFORM OFF mean that it is OFF. These are the reverse of what I