开云体育

Forgot to add screenshot, here it is

Here is TDR VSWR for your BNC connector. It seems that this BNC has about 422 picoseconds delay in comparison with supplied SMA reference. Try to measure this BNC with calibration on supplied

Hello Dave, Thanks for the reply. I've come to the same conclusion. I've ordered some tiny push switches to replace the jog/select switch (single pole three throw momentary). I can mount these

What type of switch is it? Singe pole double throw (SPDT), DPDT etc? To me at least, the unit is so poorly made that the only sensible choice is to mount it inside a box with *only the screen

https://github.com/erikkaashoek/NanoVNA

Greetings, In order to get a feel for the quality of my SMA-BNC adapter I decided to calibrate with the supplied SMA references then measure my DIY BNC 50 Ohm load through the adapter. Attached are

Hello everyone, I'm a member of NanoVNA-F develop team, BH5HNU(flyoob)'s aliexpress store is on business now. The NanoVNA-F and RF DEMO KIT is on shelf.

Hi Eric; Nice job with the extended range, plus the other added features. It mostly works OK, and as stated earlier; it interfaces nicely with NanoVNA Saver. Kudos to Rune also on his "beyond the

This thread discusses the thumbwheel switch. /g/nanovna-users/topic/32796736 In post 869 of that thread, Hugen tells us where he buys the switch that the nanoVNA ships with In post

Hi Mark. The direct answer to your question is YES. It was not my intention when I did this note to make it complicated. Instead, try to follow as close as possible a procedure that would squeeze the

I've had mine for just over a week now. I'm hoping you downloaded "STSW_STM32080_V3.0.6.zip" and a DFU file. Unzip and install this program; this is the program for pushing the firmware to your

Erik where is the 1500 Mhz code? Thx Dana

Rune where can I find the 1500 mhz code? Thx 73 Dana VE3DS

Seems I remember someone found a replacement for the selector switch for the VNA. This is a major weak point. Is there a supplier for this switch? Hal/WB4AEG

Hello, Could you clarify for us, please, if is there any certain knowledge available regarding the specific error model(s) that NanoVNA uses ? Sincerely, yin&pez@arg

I've been using NanoVNA-Saver, written by Rune B. Broberg, a member of this group. It is written in the Python programming language, so it is operating system agnostic. The code is hosted at

1. [CONFIG] -> [VERSION] (requires recent firmware) 2. "version" command on USB serial] (requires recent firmware) 3. "info" command on USB serial shows build time (available with all firmware)

Hello, Thank you once more. Sincerely, yin&pez@arg

I see the site. which program do I download to install NANOVNA software for windows?

Anyone know of a source for the multi function menu switch?? Don't need one now but bet I do....Hal/WB4AEG