开云体育

Have you looked over in either of the nanovna-V2 forums? I just found this thread there:

Hi All, I am having a frustrating driver issue. It is all the more frustrating because at some point I succeeded in controlling my nanoVNA from various software packages from my laptop, and was all

Obviously you haven't since the emails keep coming. <vk2kjj@...> wrote:

See the bottom of each email for the link

You need go /g/nanovna-users/editsub and select No Email for disable receive group messages

Stop sending the e-mail to me. I have even left the Group because I could not stop the mails CW4EVER

From the NI MAX web site: "NI MAX is only supported on Windows and MacOS, not Linux, and cannot be downloaded by itself. It is included with all NI drivers (NI-VISA, NI-DAQmx etc.) and NI System

Thank you for your reply DiSlord. I looked at both PCBs, 10R resistor for 3.3V I put in position R2 on "LCD" PCB, MOSI signals, MISO, SCLK are available on H1 connector on "LCD" PCB. The problem will

Don’t send me your emails CW4EVER

Don’t send me your emails CW4EVER

The attenuators affect more than S11 SNR when used in this fashion They are not exactly 50 ohms input/output impedance. Also the calibration errors will probably be greater as the DUT impedance is

Don’t send me your emails CW4EVER

Need use any console software (like terminal, putty RealTerm) You receive list of error tetm (used by nanoVna as calibration data) 'data 2' ED - error term directivity 'data 3' ES - error term source

Hi, Luciano... I more or less (in my head) wrote off the "extra" resistance needed to make the NanoVNA see a flat match as being to a combination of lead resistance/reactance and operator error. I

Hi Charles, I get "suspicious" when I see small differences like this i.e. 50 ohm as in this case. Assuming the black box is lossless, you should measure either 2450 or 2500 ohm if you load the other

I do not understand what you mean. Do you mean the nanovna-saver.exe window (mostly black with some status lines on it: I am not able to do a command from there)? Or is there some console within the

I worked for PWA for decades and was the only engineer that used LabVIEW, now all the engineers do. It is very easy to learn (very friendly for EEs) and yes it is expensive. So I am glad to see that

Great! Thanks. Any google search I attempted lead me to the RSGB website, which was a dead end for me. I did realize the forums were right here on groups.io, duh.

Hello, All... I recently had a need to measure an unknown matching transformer. As it was in a sealed enclosure with noth but the wire terminal and coax connector exposed, and I didn't want to damage

[image: image.png] This should get you started. Dave - WLEV [email protected]> wrote: -- *Dave - W?LEV* *Just Let Darwin Work*