开云体育

Hi DiSlord, I don't know if I continue in this thread or in /g/nanovna-users/message/23642 I soldered the holder, inserted a 10R resistor into the 3.3V power supply, connected the

not exactly, what you're seeing is the pulse that would be *reflected* back from the UUT for CH0, and the pulse that would be transmitted for CH1. Perhaps the reflection coefficient magnitude? The

On Mon, Aug 16, 2021 at 12:09 PM, Syd wrote: > > In the manual there is a Transform setup for the bandpass mode and here is the > picture of the results attached. I think this setup is strictly for

Filters ring when you pulse them.

In the manual there is a Transform setup for the bandpass mode and here is the picture of the results attached. I think this setup is strictly for measuring band pass filters, correct me if I'm wrong.

Hello Ray! Please try here: https://nanorfe.com Driver and software : https://nanorfe.com/nanovna-v2-software.html without driver works Your nanoVNA V2 not! Also, first driver, second software and fw

Have you looked over in either of the nanovna-V2 forums? I just found this thread there:

Hi All, I am having a frustrating driver issue. It is all the more frustrating because at some point I succeeded in controlling my nanoVNA from various software packages from my laptop, and was all

Obviously you haven't since the emails keep coming. <vk2kjj@...> wrote:

See the bottom of each email for the link

You need go /g/nanovna-users/editsub and select No Email for disable receive group messages

Stop sending the e-mail to me. I have even left the Group because I could not stop the mails CW4EVER

From the NI MAX web site: "NI MAX is only supported on Windows and MacOS, not Linux, and cannot be downloaded by itself. It is included with all NI drivers (NI-VISA, NI-DAQmx etc.) and NI System

Thank you for your reply DiSlord. I looked at both PCBs, 10R resistor for 3.3V I put in position R2 on "LCD" PCB, MOSI signals, MISO, SCLK are available on H1 connector on "LCD" PCB. The problem will

Don’t send me your emails CW4EVER

Don’t send me your emails CW4EVER

The attenuators affect more than S11 SNR when used in this fashion They are not exactly 50 ohms input/output impedance. Also the calibration errors will probably be greater as the DUT impedance is

Don’t send me your emails CW4EVER

Need use any console software (like terminal, putty RealTerm) You receive list of error tetm (used by nanoVna as calibration data) 'data 2' ED - error term directivity 'data 3' ES - error term source

Hi, Luciano... I more or less (in my head) wrote off the "extra" resistance needed to make the NanoVNA see a flat match as being to a combination of lead resistance/reactance and operator error. I