开云体育

yes, there are resonances at approximately any multiple of a half w

A couple of points. - You did not say how you connected your antenna to the NanoVNA. If you connected with a piece of coaxial cable and did NOT calibrate at the end of the cable you are NOT

For the sake of making an instruction for an antenna tuner I placed a dipole of length about 2 times 8 meters in my garden about 1 meter up from the ground. The idea was to get some not ideal values

You have very old firmware.? Try to install the latest from the ttrftech GitHub repo, calibrate the screen and then the RF and see if that fixes everything. FW for the H and older is all the same but

In order to show respect for the original developer, we mark the original developer information on the product. However, OwOCom recently released some instructions that it is not willing to support

On Mon, Sep 7, 2020 at 02:01 AM, Corneliu wrote: .. Designed by OwOCom. =================================== hugen was trying to properly credit OwOCom with the design of the original SAA-2 open

I received mine today. It looks great ! Designed by OwOCom.

1 - Your firmware not work vs NanoVNA-App (old, based on 0.6 version) 2 - On start sweep in NanoVNA-App - you can`t select menu (yes can, but all work slow), in this case nanoVNA 90% time answer on

Thanks Larry I try this based on your procedure at the wiki I used PuTTY (see attached pictures) However the issue remains. I wonder if there is a way to reset to factory default. Could reloading or

Where did you get the new firmware? Roger

Recalibrate the touchscreen.? On Sun, 6 Sep 2020 at 7:41 PM, Francisco Gonzalez<franciscoti5lx@...> wrote: Hello I just got a NanoVNA H. After I connected to the windows app the Menu

Yes, that does appear to be the case. I have a -H version and DFU'd the built-in firmware "1-of-11 H-LSI" and everything works well. The application's user interface makes DFU changes very easy via

When I go to calibrate sometimes some of the settings are already selected, "reverse videod". I suspect that when this happens that my calibration is not valid. What causes those settings to show up

Hello I just got a NanoVNA H. After I connected to the windows app the Menu doesnt work properly. Main menu shows up correctly but then you select any item the menu disapear. I meant the submenues

Do a search for baluns on the forum. On Sun, 6 Sep 2020 at 5:38 PM, mailscreen@...<mailscreen@...> wrote: I have not seen it addressed before but what is the best technique to

Vince, Place your Nano into dfu mode, connect the Nano to your PC, then in the device manager, delete the device AND driver that shows up. Next, right-click and search for new devices. Your Nano

I have not seen it addressed before but what is the best technique to interface the Nanovna with a 100R differential interface?

At message # 16998, OneOfEleven again provides access to your GitHub. There you will find your FW, which allows you to clear the configuration through the menu. You will also find the nanovna-app

Yea I saw that, I unfortunately can't connect to the unit in terminal mode to execute a clearconfig command. I can't see a com port for the device on windows 7 using the virtual drivers. It's sitting

I only got beeps to and no scanning on an older firmware release. Apparently OneOfeleven's program requires firmware that supports a newer data transfer mode. Roger