开云体育

Hi Yes here it is Remember to set a frequency span e.g. 0.05 to 500Mhz then calibrate and save to e.g. location 0. Then follow the steps described in the right side I see you missed that Kind regards

The problem I had with the big noise in the phase chart of NanoVNA-Saver was because I was measuring the load standard I had used for calibration. The Returnloss measured after calibration was that

Mrs. Maggie is doing very well, correct. After I sent the money, I asked if it had been received. He replied that he did and sent a pdf of the shipment with a photo of the shipment. You can follow the

Here's what my 2 core FT-240-K choking impedance looks like. X=0 a little above 11 MHz after which X is capacitive.

Works perfectly with me, any firewalls or antivirus protection hyperactive? OE8UWW

Sorry, can't get the file from http://ha3hz.hu/images/download/nanoVNAPartner0.20.rar nor /g/nanovna-users/wiki#nanoVNA-Partner, Any suggestions? Oristo <ormpoa@...> 於

Thanks, Gyula; link updated at /g/nanovna-users/wiki#nanoVNA-Partner

Hi Bob, Please download from: http://ha3hz.hu/images/download/nanoVNAPartner0.20.rar neb sent it to me for testing, which I gladly did. Since I didn't get a detailed description, there are a few

Bonjour Pierre, Non, il n'y avait pas de possibilité de contr?le par le port USB dans le firmware. Je te joins le schéma récupéré auprès du vendeur. Cordialement Jose

The on/off switch is a good point to provide a clean 5Volt. I use the free pin of the switch to connect to 5Volt so when I switch off it connects to the battery And Yes, when running from a 5Volt

Hello Kurt, Do you please have an example for measuring coax impedance with nanoVNA partner version 0.20 ? Unfortunately neb40gsm does not provide any help info. Attached is:

perhaps off-topic but this is the first item of interest to me. keep it up. much of the list is just nattering. wrote:

No ... that simply isn't true.? W4OP is correct for the reason he states. Whether on topic or off topic, this isn't the place to be spreading bad information. Dave?? AB7E

I agree that this topic is outside the general outlines for this list, but then again I didn't bring it up.? For anyone who would actually like to understand what makes a good common mode choke,

I have a similar problem.? When you find the answer, let me know. I replaced the 5303 with another 5303 and it's better.? My second nano needs similar repair; it won't start up with the USB

I have a bit more information.? I have a cable going to a coaxial switch that shorts unused connectors.? So the cable, unless I select it, has a short at the end. The procedure, with slight

FYI, I just replaced my ip5303 with a ip5305 and did NOT resolve my power on problem.

More L, more 2pifl, better reflection.

I don't believe that the primary goal of a choke should be high L. Indeed if the system had a net C then the series L of the choke could make common mode worse where the L and C resonated. High

Kurt, I went there and downloaded the file but am told it's corrupted. Bob