开云体育

Use SimSmith.

Anne, Actually, I'm more interested in determining the matching range of a tuner with various antennas. I've used the AI1H method** of testing various tuners but that's a static resistance method.

Nice topics Barry just one small (nitpicking) remark on the wording in 3) Why does every feed line have an SWR of some value at some frequency? Actually it's not the feedline that has an SWR 'of some

My NanoVNA-H in the plastic housing (delivered in the black gift box with golden letters) has a big sticker on the back telling it has HW version 3.4 (this is the one with serial THT holes on the left

You may have turned off the calibration.? Go to the base menu, click calibrate and make sure the Apply button is checked.? On Wed., 7 Jul. 2021 at 7:44 p.m., Anne Ranch<anneranch2442@...>

Is this normal ? I have not checked my nano firmware version , got other "honey does" I am just curious , not panicking , not yet. On initial power -up I get splash of white screen then splash ,

Originally I did not see much benefits to put the nano into a box, however, after "reading the mail " here I see a "major" issue with the SMD coax connectors breaking off. So I am not after making it

On the newer -H boards (not H4, as DiSlord has shown) there is a simple set of 4 pads in a row with V+, Rx, Tx, and Gnd. This is eaxctly what's required to connect an HC-05/06/... Bluetooth module.

That isn't a problem with Linux.

I remember wbw a 100 foot piece of -48V 500 MCM being modeled as R+jinductance and C to trough. We were wondering what impulse it would take to raise -48V to 0. Turned out a disgruntled employee was

I did just that on my 2.8" nano but a better idea is to add a header and connect the BT dongle when needed. wrote:

Hello Dislord, Is it possible to install the HC-05 or HC-06 bent down inside the NanoVNA H4-casing? Or will that disturb the Nano? 73/SM6AYM

A DC source has no complex portion and is not characterized by impedance, only the real term in the R ± jX. Further, if no current is drawn from the source, the presence of the R term isn''t there.

NanoVNA-H/H4 contain free pins named as Rx and Tx (you can see pcb or scheme) Exist connection modules like HC-05 or HC-06 It allow easy connect any device vs UART port over Bluetooth, device need

Pardon my ignorance I assume yours is software only solution. ( I did not read your posts in detail - so forgive me if it is there ) I see few posts "solder wire to ...." and I would prefer NOT to do

I was thinking about how to make full two port measurements.? The easy way is to get a coax transfer switch.? But given how cheap the NanoVNA is (i.e. less than the cost of the relay), what about

How connect /g/nanovna-users/message/17758

You can use my firmware, it allow connect to PC over any Serial TTL module HC-05 or HC-06 Or use any WiFi to TTL Search this forum for more info

When I joined this forum - abut a year or so ago - I also started my CAT bluetooth project. Hence I asked few questions about if there are any plans to add bluetooth to nanoVNA. I actually went as far

I cheat - I run nanoVNA-saver to find the "port" . After few hick-ups I am getting pretty familiar with nanaoVNA-saver and it really does not bother eif it was written in Python HI HI