开云体育

I used Mouser PN 652-CG0603MLU-05E. All the information was in the link that I gave above. They are tiny and you need a fine tip low wattage soldering iron. Good luck

That latest firmware from DisLord , V1.2.00 adds the following :- additional 4 admittance marker format and Admittance background G + jB G + L/C Rp + jXp Rp + L/C ? Add text keyboards for input

Thanks for all the good info. I apologize for getting off topic. So getting back to firmware... I've learned over the years not to toy with flashing firmware unless there is a problem that absolutely

Anything other than 50Ohm j0=0 is a loss.? So trotting along the 50Ohm line is also lossy.Total impedance involves both the real and imaginary parameters. Mike W9MDB

Hi Dave & Friends! What is the working voltage of ESD suppressor diodes? What model did you use? ?n mar., 4 oct. 2022 la 22:48, Dave via groups.io <dvfuller= [email protected]> a scris:

Thanks. Downloaded and having a good read. Regards Rob aka G4ZEO

I tried to remove the screen, loosen the screws, use it without the screen, but the problem is always the same: it gives me the first drop-down menus but not the submenus. Please help me, I need the

Assuming a lossless transmission line stub, the Smith Chart trace will move along the outer edge of the chart as the frequency/electrical length changes; losses bring it spiraling in from the edge.

If the termination is lossy (other than 0 or ∞Ω) the result at the other end of the stub will be a lossy inductive or capacitive element. I learned this when using λ/4 stubs to bias microwave

Thank you for speedy reply. I am a complete novice in this area. I bought it to check my antenna. I usually update my devices if needed first. I am at a loss to understand all the / parameters etc and

Thanks, Jim! How quickly we forget! Your email is now stored on the HD, printed, and destined to go into my notebook of indispensable kernels of knowledge. Dave - W?LEV

If you want ESD protection on your VNA or tinySA refer to this group's thread. I ordered these ESD protection diodes and installed them in my two tinySAs and my nanoVNA. They work perfect.

You may find it helpful to read "The absolute beginner's guide" which can be found in the files section of this group. It has very good basic information and details on firmware update procedures.

Hi Rob, DiSlord supports the NanoVNA-H (and other devices) actively: https://github.com/DiSlord/NanoVNA-D/releases/latest Martin

Not *any* - for a given length, you get a circle/spiral on the Smith chart of values Impedance transformations If a load of complex impedance Zload is connected to the end of a transmission line of

Can anyone tell me the latest version of firmware and link please. Totally confused so far. Thanks

Yes keeping in mind the termination need to be a short or open. Then as a function of length and frequency any +/- imaginary value (C or L) can be presented at the other end. Lester B Veenstra K1YCM

Lester, Sorry to scope creep on the thread but this is interesting. so you are saying that a parallel tuning stub could be open or shorted and depending on the length to termination, could be seen by

Yes, you can make inductance or capacitance with a shorted or open stub, with some limitations.

Both will work, of course, different lengths at a given frequency for the same inductance or capacitance at the user's end Lester B Veenstra K1YCM M?YCM W8YCM 6Y6Y lester@... 452 Stable Ln