开云体育

I have an early H4 (from Hugen's store), so I've have no issue re-jigging the case yet again. I do hope Hugen will make available extra shell/mold/cases when he implements the latest design change; I

Looking at the schematic of the rev3.4 pcb I think there may be an issue with using this connection with HC05/HC06 type BT modules. The power pin on P3 is connected to the 3.3V Vdd of the nano. The

On Fri, Sep 4, 2020 at 09:21 AM, Dex W4DEX wrote: Is this device available on eBay from a reputable source? I tried to register with AliExpress but they require a phone number which I refuse to give.

Is this device available on eBay from a reputable source? I tried to register with AliExpress but they require a phone number which I refuse to give. Dex

Arrrgh. correcting my typo Which should be "Tx on HC05 to Rx on nano ..."

On Fri, Sep 4, 2020 at 08:38 AM, Klaus W?rner wrote: The software of the SAA2 has an option to adjust the power. I have not tested, if it really works. ================================ Klaus, VNA-QT

On Fri, Sep 4, 2020 at 08:06 AM, @switchabl wrote: It depends. The problem is that adding an attenuator at the test port will degrade the (raw) system directivity by _twice_ the attenuation value. So

The software of the SAA2 has an option to adjust the power. I have not tested, if it really works. -- Klaus, DL5KV

Offtopic by this point but: There is probably something wrong with the settings at your store as the Aliexpress standard shipping is available for Albania, Macedonia, Bulgaria, Romania, Hungary,

On Fri, Sep 4, 2020 at 07:49 AM, Russ@va3rr wrote: Has the case been modified to allow outside insertion of the micro SD (TF) card? I added the card reader to my H4, but I'm debating modifying the

It depends. The problem is that adding an attenuator at the test port will degrade the (raw) system directivity by _twice_ the attenuation value. So while in your case it works fine, if you were to

Hugen said in his mesg that the case has not been changed yet.It's no big deal to cut a slot - only on one half of the housing - you can nibble away with small sidecutters and trim with an exacto

Has the case been modified to allow outside insertion of the micro SD (TF) card? I added the card reader to my H4, but I'm debating modifying the existing case, or trying to order a new case from

Yes, we installed microSD for the latest nanoVNA-H4 after DiSlord completed the microSD migration. Since we have not completed the modification of the shell mold and have not reserved an installation

On Fri, Sep 4, 2020 at 06:38 AM, Bob M. wrote: .. Are there any NanoVNA products, of any version, that have an adjustable Port1 output level? ===================================================== Bob,

Igor Jobim posted on another group that a friend had recently received a NanoVNA-H4 from hugen's shop. He included a photo of the pcb board it it showed that the NanoVNA-H4 his friend received had a

Are there any NanoVNA products, of any version, that have an adjustable Port1 output level? My V2 unit's output is -10dBm and while that's great for working with passive networks, it's a problem for

Designing the cases required several nights of hard work and design choices has been done in order to : - Accommodate a large enough battery and internal stylus fitting - Have no visible screws on the

Keysight "RF Microwave Signal Chain & Network Analysis" webcast added to External links: /g/nanovna-users/wiki/13116

Dragan Milivoevich Meggie sent your letter to me. I understood that this was a mistake.