开云体育

I got a set from Amazon for like $15 US. 2 so239 and 2 pl259

Why are the two measurements not taken in the same display format? One graph is in SWR one is in RL. Tony VE3DWI. [email protected]> wrote:

Thanks Roger!

Here is a photo of a Hugen 3.4. looks the same as Jason's

Close up of the other one

Close up of white one.

Jason, It could be a genuine Hugen 3.4. Hugen posted that he does sell them with "sandwich" type construction instead of in a plastic case with the gift box. Roger

Captured in the wild. I am aware the white one is an inferior clone but the black one appears to have a newer pcb and has a version 3.4 screened on the pcb. Is this a genuine one? It has a different

| On Tue, May 19, 2020 at 09:48 PM, <sj@...> wrote: = | | I would say NO. | Sorry to say, but have worked with VNA's for 30 years and as soon as you come | near 1/8 wavelength the measurement

Here is a file containing the R+jX comparison from the experiment above. Sweep at feedpoint and at end of 55 feet of RG58 overlay on top of each other. Roger

I respectfully disagree. My NanoVNA was calibrated from 2 to 50 MHz using NanoVNA Saver. Then I measured a 20M dipole at the feedpoint and saved the results as an S1P file . I added 55 feet of RG58 to

We have a couple of small dealers selling them.

Yes, intended to put "(small screen)" after SAA ...

Stevepilot; It was being held. Apparently, no aircraft cargo space was available until just a very few days ago. -- *Mike* , K0JTA /g/Visible-Cell-Phone ?\_(ツ)_/?

I would say NO. Sorry to say, but have worked with VNA's for 30 years and as soon as you come near 1/8 wavelength the measurement errors are taking over. You know, in the analyzer the matrices that

Sorry the- H4 has a bigger screen and a lot of extra's in DiSlord firmware , I think you mean the H. Op 19-5-2020 om 17:27 schreef Dragan Milivojevic:

Calibration using SO-239 or PL-259 connectors is marginally useful at lower frequencies like the HF band because it is not an impedance controlled connector. The link below is the only commercial set

Question is Mike - why from 6th May to now to get to USA ? Hong Kong is the problem and has been pre Covid too :(

Does anyone have a source for a set of calibration standards on PL-259 / 239 connectors? Yes, I know I could “make them”, but I’d rather buy them! ;) -- Regards, Chris

Way too expensive. The different versions are explained in the wiki: /g/nanovna-users/wiki Choice is practically between 3 versions: F (large screen), H4 latest revision by Hugen of