开云体育

I have one.? I am happy with it, except that the USB connector is only soldered to the circuit board, rather than screwed to something solid.? I read somebody's report that the connector had come

Hi all, I'm installing the Linux version of nanovna-saver on a netbook with a 32-bit Debian 10.1 installed. I have installed all the required packages but when I give the command python3.7 -m pip

Garry Thanks for the feedback. I tested also with a better semi rigid cable. The model finds a somewhat different R, I guess the cable has a bit different impedance but the imaginary part is the same.

To analyze possible confounding factors, modify: main.c cmd_vbat() - chprintf(chp, "%d mV\r\n", vbat); +/* needs adc_stop(ADC1); ?? */ +chprintf(chp, "%d %d\r\n", adc_vbat_read(ADC1),

No, this is TRACE 2 baseline marker :)

Hi Erik; I think your assumptions are incorrect. To achieve what you are attempting requires your test cable be free of imperfections. In truth, the cable is not likely precisely a constant Z0 equal

Kurt suggested that very good cable is wanted, e.g. airline. I notice better results from LMR-400 than RG58 or RG316

After calibration with the correct calibration error parameters, a 1 meter cable connected to the reference plane with short and open at its other end, should give perfect circles spiraling inwards in

QRP RX recently updated his README: https://github.com/qrp73/NanoVNA-Q/blob/master/README.md

Bob, https://www.aliexpress.com/wholesale?catId=0&initiative_id=SB_20191030105308&SearchText=IP5303 But be careful - some vendors charge big $$ for shipping.

Where to buy IP5303?

Thanks for the image, KVR5 Your hand is steadier for soldering than mine.. @QRP - does the small red mark next to it signify bad hardware?

That's exactly what I do at LC. "You can also connect trap to hot ends of both CH0 and CH1 and do S21 measure without need for coil adapter. It worked for me when I was unable to detach trap from

IF your reply DID NOT start with put-down I would reply....

IF you would have looked in the Files and Wiki sections of the forum - all of your questions would have been answered except #1.There is no trademark - only a copyrighted name, owned by edy555. Check

Sure, but one fixed LPF suffices, rather than LPF tracking swept square wave.

Before purchase I would like to have the following answered / verified Is “NanoVNA” a trade mark? (verify) Is “NanoVNA” open source – both hardware and software ? (verify) “NanoVNA “ is

connect it to CH0, leave CH1 open

There is a testing of hardware, to make sure that it provides adequate measurements. With calibration enabled possible hardware issues will be hidden by calibration. This is why I asked for screenshot

Do the same with load on CH0 and CH1