开云体育

added to Wiki Main Menu: /g/nanovna-users/wiki

I looked for BNC with 0.1" spacing, but so far found only this: http://daqstuff.com/500057_brd_bnc_conn_kit.htm

Need to place the file with the electrical circuit separately. Some do not suspect that it is in the instruction manual. Many questions will disappear.

31 : On the Uncertainties of the "Standards" - Part II - 23 : On the Uncertainties of the "Standards" - Part I - 30 September 2019 /g/nanovna-users/message/3517 @ Jeff Anderson

Thanks for the response! So, if I * properly calibrate at the VNA port * plug in a candidate cable terminated with calibration load * observe no appreciable reflection .. then that cable unterminated

Hello Oristo Yes just by using the Electrical delay, but there is always a but, the delay in a transmission line is frequency dependent and if the impedance is not precise 50 ohm we might have an

Hi Rune, I just tested a SFZ450F ceramic filter. First I had set a span of 50kHz and I set 3 markers. Than I changed to 50kHz span and all the markers were gone. If you try to set a new marker in the

What "a can of worms" this subject opens up.?I noticed the Hewlett Packard rarely if ever referred to return loss as a hardware specification; it was always specified in terms of SWR. Personally I

Another option, If you want to plot smith charts from Touchstone .s1p .s2p files, Simsmith also does this. It is Free. <http://ae6ty.com/Smith_Charts.html> I am eagerly hoping someone integrates this

The internal LiOn battery (if connected) is like 3.7 to 4.2V. It is normally charged from externally-supplied USB 5V. This suggests to me that the innards run on something less than 3.7V (most likely

You must have a very cheap source of the ADF4350 since MAX2871 is just around 8 USD. Which RF switch do you use to switch between the si5351 and the ADF4350? Most switches are not specified below a

Could always try! But it's not first on the wishlist. I'll keep this thread linked on the backlog :-) -- Rune / 5Q5R

so - this is something that Rune might be able to add to his 'Saver application?

Oops, This was not meant to be sent to the list, but privately to someone who emailed me on the subject. Anyway, I stand by what I said 1) Return loss should be positive for passive components. 2) I

Yes, I am G8WRB. The problem is return loss is *often* used as a negative number in professional academic publications. This one from an IEEE, has a particularly amusing title; Low-Return-Loss Printed

From my limited understanding of the Y factor noise measurement you only need to measure power ratio in a not so critical frequency band. Correct? If yes. The CH1 input can function as a power meter

return loss is (almost always) a positive number. If one insists on negative numbers, just call it s11 (or s22). In essence the same property, but negative. Op 4-10-2019 om 17:20 schreef Ron Spencer

I think folks here are reporting 2-4 hours depending on the size and age of battery.I hear units come with 300mAH up to 450mAH batteries.? YMMV

No, "Demo" may be an historic artifact from the original author. STM makes the software freely available to encourage use of its STM32 technology. Yes, but you need that only if some other firmware

HOWEVER: The frequency steps on the NanoVNA are quite large depending on the settings. Now, with that said, maybe Rune can create an SA NanoVNA-Saver offshoot application that would perform