开云体育

What is the Rflna slider, what is its purpose?
What is the screen got when hitting the Bscope button?
How can I show the "slider 0 to 100% to change the transmit power", which is indicated in the HL2 - Bands - Tx level comment?
73 - Pierre - FK8IH

On Tue, Feb 27, 2024 at 12:51 AM, Pierre FK8IH wrote:

What is the Rflna slider, what is its purpose?

I controls the RF low noise amplifier in the HL2.

What is the screen got when hitting the Bscope button?

A bandscope display is the whole RF spectrum received by the HL2.

How can I show the "slider 0 to 100% to change the transmit power", which is indicated in the HL2 - Bands - Tx level comment?

I don't understand.

Jim
N2ADR

Jim,
Thanks for your answers.
About the last point you don't understand: I read in Config-HL2-Bands-Tx Level the following (i) "This sets the transmit level 0 to 255 for each band. The config screen has a slide 0 to 100% so you can reduce the transmit power..." I don't find this slide, where should it be. I'm using v.4.2.29.
Pierre - FK8IH

Hi Pierre,

Just in case you haven't found it yet (I just read your question).
If you select config using the "Config" button on the screen, then choose the "Config" tab then
the "Tx level" slider is the 7th item down on the left hand side.

73, Neil G4BRK

Thanks Neil, I found it. I thought it was on the main Quisk panel with all the other buttons and sliders and I did not look inside the config screen.
73 Pierre FK8IH