开云体育

Hi All,

On 20 meter and selecting usb mode when I press PTT power output is ONLY 200mw? but when I change the mode to AM, PTT power output is full 5.5 watt

It happen with all mode except AM. I can not send FT8 messages in all bands as USB or LSB is default selected for 20/40 meter band. I have kept selected full duplex mode. When I press SPOT it send full power but not sending full power with PTT

Same HL2 with Spark 2.033 send all FT8 with full power 5.5 watt..

Can any one help me...?

Regards
KESH VK2KES

When WJTX calls for tx, I can see PTT button in action Tx red happens automatically but in reality there is no transmition taking place. Power shows 0 watts and Ampl 204ma..spot is set to highest point. In the config HL2 hardware section Enable power amp is set to true. Digital Tx power % is set to 100. In Band section all band are set to 255 values. In config section both bar 1Tx level 2. Digital Tx level both? set 100%

I do not understand what I am missing.? Jim please help...

USB will not send any power until you speak into the mic. Try whistling into the mic to make a constant sound and see if the power goes up.

Jim
N2ADR

The digital program must connect to Quisk with audio devices. Check that the audio devices are correct on both programs.?

Jim
N2ADR

Problem Solved...

Hi Jim,

Thank you for pointing to right place. I found that there was no audio in comming from WSJT. I set it to virtual com port and it started working. Now WSJT can send FT8/FT4 will full power 5.6 watt using USB mode.

My FT8 signals are now reaching to USA on a 5.6 watt transmission...amazing...

Thank you Jim for your help and time.

Regards
Kesh VK2KES

Request: I am very qurious for HL2 IO board as I have Ukrainian transverter to be tested with Quisk 4.2.21 + HL2. If IO board? left then I am keen to test and provide you test results.