开云体育

Hello Gil, Full duplex was meant as a test function. I will think about how to implement your request. Jim NADER

Hi, Jim. Thanks for the quick reply. Just gave it a try and in order to then hear the other station I have to unmute and since I use vox that is very cumbersome. My contact buddy did bring up a second

Hi Jim, I am intrigued by the open-source gnuradio toolkit and, particularly, the associated graphical tool known as gnu radio companion (GRC). The essential toolkit includes various chunks of code

Hello Mario, Try a different waterfall pallet on the Config/radio/Font screen. Or you can put your own pallet in a config file. Jim N2ADR

Hello Bruce, The messages mean that the USB device is not available. Maybe allowing time between Off and On will work. The USB device may need time to reset. If that doesn't work, you will have to

Hi Gil, Use the Mute button. Jim N2ADR

Hello Terry, Compiling Quisk for Windows is difficult. That is why I supply four binaries for Windows, Python2 or 3 in 32-bit or 64-bit versions. Just use your Python to install Quisk, and it will

HI, wondering if there is a way to stop the voice monitor when using FDX in 4.1.52. The latency is far too great for my ears, but do like to see my transmitted signal portrayed on the graph screen.

My miss read ... steve is on Windows .... I'm familiar with linux/openSUSE [email protected]> wrote:

Steve ... are you on windows or linux?

Wonder if anyone can help with this one. Trying to use qusk to drive a lime SDR mini with the soapy interface. Downloaded and installed pothos SDR 2020-02-26. It complained on installation that it

Hi Terry Just put it in the main source folder along with all the other header files. The problem I got was after that in the handling of complex numbers. I think Quisk (correct me if wrong Jim) uses

Hello David, thank you for responding to my question.? I get my error after entering "pip install quisk".? Any other ideas would be appreciated. Terry N8AB

Hello Dave - Thanks for your message.? I have the missing header file, but not sure which folder to copy it to, to get it to complie without the error.? Still a bit lost for the solution. Terry N8AB

Thanks Jim, I took your start on getting this to work and with a number of changes, probably for python3, it works nicely.? I did a pull request where I got the original code, and the changes were

Hi Jim, This seemed like a good thing to try. I finally found a few minutes to do it. Changing to DEBUG = 1 produced quite a string of messages that I can't immediately make much sense of, with QUISK

I haven’t been keeping up with the Charleston SDR with Quisk. But, I can catch up with this in a little while since there still seems to be some interest! I will wade into Quisk and fix it up. Linux

Hi, just one question: Has the support for the charleston-sdr receiver (i think it was from around 2010) been removed or should it still work? I still have such a board flying around here and wonder

Hi Jim, i already tried with the sliders but the adjustment range seems not wide enough. Please see the screenshot. regards Mario

Hi Terry Wonder how it's going? I also tried building with VS 2019 but ran into problems - basically over the way that Complex are (not) handled by the compiler. Using Clang improved this but not