开云体育

Seems that I was blind for the drop-down "Midi device name" in the right column yesterday. Perhaps I looked only into the left column or thinking, that the right column is related to CW only. Anyways,

I am trying to use my "Hercules DJControl Compact" together with the MIDI capabilities of Quisk 4.2.30. I tried it on * Windows 10 * Linux Mint I could validate on both platforms, that the

Thanks Neil, I found it. I thought it was on the main Quisk panel with all the other buttons and sliders and I did not look inside the config screen. 73 Pierre FK8IH

Hi Jim, very good to know - thanks! 73 Michael, DK1MI

Hi Pierre, Just in case you haven't found it yet (I just read your question). If you select config using the "Config" button on the screen, then choose the "Config" tab then the "Tx level" slider is

Hi Mario, Thanks for this info and thanks to Michael for his post which reminded me to try it. I now have my VFO knob mapped (on a Serato DJ2GO) to tune. 73, Neil? G4BRK

Hi Mario, Thanks to you I was able to map the VFO knob of my DM4DS Midi controller correctly. Very much appreciated. +1 for adding this to the config screen. 73 Michael, DK1MI

A new option "Tx-Rx silence msec" on the Timing configuration screen controls how long to suppress Rx audio when switching from Tx to Rx. The previous fixed time was 50 msec. The SSB squelch control

Hello Stephen, I will extend squelch to CW in the next release. Please test, as I am a little worried about latency. You may need to turn off squelch once the net starts. Jim N2ADR

Jim, Thanks for your answers. About the last point you don't understand: I read in Config-HL2-Bands-Tx Level the following (i) "This sets the transmit level 0 to 255 for each band. The config screen

Thanks Jim! Rob ________________________________ Sent: Sunday, March 17, 2024 2:05 PM To: [email protected] <[email protected]> Subject: Re: [n2adr-sdr] Quisk Error on pip install (Cannot open

Please see freedvpkg/README.txt for information. Jim N2ADR

I controls the RF low noise amplifier in the HL2. A bandscope display is the whole RF spectrum received by the HL2. I don't understand. Jim N2ADR

This is a good time to train your students to read the documentation. Quisk does not work with Python 3.12. Once there is a version of wx that works with 3.12, and once I get some free time, I will

Hello Rob, The sdriqpkg directory was eliminated, and the Python hardware file quisk_hardware_sdriq.py reads the Rx I/Q samples up to a rate of 185 ksps. This interface is worth a try. You will

Hello?Jaroslav, I do see your point. But it is not easy to do. First, the HL2 does not know if there is an ATU. The "No ATU" message appears if there is no IO board. And the bottom row with the "ATU"

Thanks so much. You reported the problem, solved it and provided a fix. Nice work! Jim N2ADR

Hi Jim, thanks for fixing the docs. But I still think the code also needs update. I think if no ATU is available, the GUI should from the start shows the "No ATU" message. Now, if Quisk is started it

Thanks Jim, I made a lot of progress on this now. I have decided to leave the serial port until later or never because UDP is so much faster and easier. I can do 96 kHz on most WiFi networks instead

That is true, but you could also write your own hardware file and put your logic into ChangeBand(). This is called whenever the user changes band. Jim N2ADR