开云体育

What computer and what OS? Mike W9MDB

Hi: I think I'm seeing something unusual in the behavior of the digital mode for fldigi and wsjtx. When I key up in either program, the output starts out at a lower level than normal and only

If you want a bit between the commands does it work OK? Hamlib is simply asking Quisk for current frequency and it SHOULD be waiting for Quisks' set_freq to finish. So try this and send me the output

This is a continuation of a previous thread whose subject matter had drifted from its starting point. Essentially, this relates to a problematic update of Quisk running on an RPi P400 with the default

I should mention wsjtx also fails to coordinate frequency settings with this version of quisk and hamlib rigctl. Random frequency changes occur as wsjtx periodically attempts to update tuning status.

Add -vvvvv to see what's being returned. I suspect if you wait just a little longer you'll get the right answer. Mike W9MDB

I removed the original rpi4 hamlib package and installed the latest from source. I also installed the latest version of Quisk from PyPi (as of a couple of weeks ago). I still see confusing behavior.

Problem Solved... Hi Jim, Thank you for pointing to right place. I found that there was no audio in comming from WSJT. I set it to virtual com port and it started working. Now WSJT can send FT8/FT4

Thanks!

The digital program must connect to Quisk with audio devices. Check that the audio devices are correct on both programs. Jim N2ADR

The Quisk settings are in the files quisk_init.json and quisk_settings.json. These should be in your Documents folder, but you may need to search for them. Jim N2ADR

USB will not send any power until you speak into the mic. Try whistling into the mic to make a constant sound and see if the power goes up. Jim N2ADR

There is a new IO board being developed for the Hermes Lite 2. Quisk communicates with this board by reading and writing registers in the board. The register numbers changed so I needed to make an

When WJTX calls for tx, I can see PTT button in action Tx red happens automatically but in reality there is no transmition taking place. Power shows 0 watts and Ampl 204ma..spot is set to highest

Thanks! I looked everywhere but there! I will report back if this doesn't resolve my issue. 73

Hi, a while back I saw the same thing.? There are quisk files in your 'MyDocuments' folder that should be removed.? You may have to only remove/rename 'quisk_settings.json' Hope that this helps,

Hi all, I had Quisk running on Windows with no issues, however I made some changes to soundard settings and now Quisk will crash (and close) as soon as the GUI loads. To try and resolve this I have

Hi All, On 20 meter and selecting usb mode when I press PTT power output is ONLY 200mw? but when I change the mode to AM, PTT power output is full 5.5 watt It happen with all mode except AM. I can

Hello, Jim! " has the new IO board register numbers " - what does this mean?

This version includes Windows support for Python 3.11. It also has the new IO board register numbers. Jim N2ADR