开云体育

Hello Jim, Keeps getting better, LNA slider works as you have said and is the best solution. I have one bug to report which has been through several recent versions: The Config/TX Audio screen has no

Hello Peter, Each remote radio requires a custom hardware file at the control head. There are only files for SoftRock and Hermes, not HiQSDR. I will write one for the HiQSDR when I get a chance, or

OK, I will have to drag the service monitor up there, but will have to wait until the snow clears a bit!? I thought I could adjust it by tuning a carrier, of which there seems to be many.? I can get

Hi Jim, As I intend to use Qusik as panadapter, I set the VFO frequency in Quisk to 10.7 MHz. This works and is copied into the quisk_init.json as "VFO": 10700000. After a restart the frequency is

Hello Nigel, I tested on a local machine (no remote feature) with my RxTx Ensemble and everything seems to be working. When I inject a sine wave, the slider controls adjust the image to zero. And I

Here is the working version of the tune botton widget. Thanks to Harald, OE6HKE. de oz9ny, niels

Hello Ben, thanks a lot, that really helped. I'm attempting the same for the Hardrock 50 Amp. So I got some text widgets and a tune button which triggers my method. All good so far. I also hooked into

Thanks for the update, Jim, it no longer crashes when I try to set the phase.? I get the phase and amp adj boxes above the minimised spectrum display, but the spectrum display doesn't show any

Hi Jim, I forgot to add the logfiles from both systems, I hope this helps. Peter

Hi Jim, I ran tests in the small screen mode, but first a disclaimer about my setup. I run Ubuntu 18 on the Remote and Ubuntu 20 in the Control Head. On the remote Python 3.6 is running, Python 3.85

I made the Hermes LNA slider control value persistent. This make more sense than having it be a configuration setting. When using Quisk Remote, band changes from WSJT-X now correctly set the HL2

Hi Ben and Jim, I have my own home build transmitter hardware , so I replaced the hardware specific softrock radio file with my own. The challenge I have is trying to get the HiQSDR working across

Thanks Jim for this new release. Now remote works well with our low bandwith internet setup. I hope to try soon from an hotel. Best 73

Thanks for your kind attention! I will await it eagerly! 73 Nigel Nigel Johnson, MSc., MIEEE, MCSE VE3ID/G4AJQ/VA3MCU Amateur Radio, the origin of the open-source concept! Skype: TILBURY2591

Hi Jim, Thanks for the reply, in next instances I will use the "Ask"? statement! Yes, I am endeavouring the small screen solution, but will use the large screen solution for now until your next

Hello Peter, If Quisk will not start due to bad settings, start quisk with the "ask" option: python quisk.py --ask Then specify a different radio to start. The ConfigFileRadio always works. Then

Solved, that's to say, I changed the settings in the config.json file and managed to get Quisk running again. I need to figure out how to run the Control Head Quisk as a Pandapter (Hence, no need for

Hello Nigel, This is a bug that I will soon fix in the next release. Jim N2ADR

I have installed Quisk 4.2.11 on a freshly-downloaded copy of Pi OS on a headless pi 3B+. It is connected to a Softrock RX ensemble and the whole system is in the boiler room of my condo building 5

Hi Jim, While setting up a control head, I cleared all the band buttons, as the control head needs to serve as a pandapter (I have more questions how to connect to the remote unit using just the