开云体育

I'm transmitting into a load (the softrock output is about 2mw), and using the dongle antenna, a few feet away.? I could set up a separate attenuator, but I've found that sufficient for working on my

How much attenuation have you put between the SR TX output and the RTL dongle?

(Sigh!) Back to the drawing board.? Yes, I'm getting signal out - wide-band noise only. I'm using a RTL dongle as a poor man's spectrometer on the output of the softrock (on 28).? The signal is

Glad you solved it. I gave up using QSD/QSE? SDR's as I never found sound cards to be satisfactory, adjusting amplitude and phase never seemed to have any effect. With DDC/DUC SDR's a simple USB

FOUND!!! Crazy thing.? Since my transmit audio in won't be over 2.6K or so (JT65/FT8/PSK31/voice/etc.), I'd had the mike audio in set to 8K (one of two settings).? I thought I read somewhere that

Hi Jim Apologies for the delay in replying. The problem is also present in the 32 bit version - Windows 10 32 bit, 32 bit Python 3.8. FreeDV button greyed out. Just in case it was path related I

Thanks!? That might help. I'm wondering if there is a module or driver that is interfering - something that needs to be blacklisted.? I know for a while it was intermittent - the transmit levels

Hello, I will add a feature to the next Quisk release to show the audio level for each connected sound card. It will be on the Config/Status screen. That should help with debugging. Jim N2ADR

The current settings file is ~/quisk_settings.json On a new computer I usually remove ~/.quisk_conf.py and use the quisk Config tab to set up a new radio. It's a long time since I've used the SR v6.3

Nothing that shouldn't be.? I've muted some of the features of the built-in audio only.? The two USB sound cards - they both are fine as far as the settings (checked with both alsamixer and QasHctl

Have you checked with alsamixer to make sure nothing is muted? 73 ... Sid.

I tried different combinations - none would put out an audio signal that could be detected (if it was there, it was below the sensitivity of my scope - which is more or less usual for decent moderate

I have experienced similar problems with Linux Mint 19.2 (Ubuntu 18.04 based). Have you selected the right pulseaudio devices in your sound settings? 73 Nick G3VNC

I noted that there was an updated version, so I did an upgrade (4.1.51).? No difference in symptoms.

I've got a major headache - I don't know what changed, but I cannot transmit anything with my softrock - no signal out. The setup: Softrock RxTx6.3 modified for broadband use (wideband low power

Hi Peter/Jim, It took me some time to prepare my 2nd HL2 (build 8) for testing but now I am quite ready ! It seems that when running two HL2 simultaneously in the same network, they should receive

Hello Gil, There have not been any changes to Quisk that are relevant. Please ask on the Hermes Lite group. I remember seeing this problem, but I don't remember how it was resolved. You could also

everything normal for me too (Ubuntu 18.04)

Hi, I am only able to get 2 watts max out from my HL2B5, How can I increase to full power? Spot is at max. Thank you? ? ?Gil? ? ? K8EAG

Hi Jim.Its? in the version 4.1.51 i downloaded, (24 November) installed at /usr/local/lib/python3.6/dist-packages/quisk/soapypkg/ Using aarch64 Ubuntu 18.04. rpi4. Dave.g0vvf.