开云体育

My latest project a adaptor for a 48mm four jaw chuck to my 3" rotary table .

I have larger but nice small for fast setup and not have take off the vise on the mill.

?

?

Red Dykek read to layout for mounting hole?

?

Note tap hole in the center this for holding down parts in chuck like drawbar.?

More photos and drawings on the 48mm chuck.?

?

?

Machine tools are great for making more tools.? I like that your lathe looks like it's used, not a polished store display.? I'm naturally scruffy and my tools often look the same, I'm not big on polishing except when needed.

?

I need to mount the X drive on my mill, that was one of the things stolen.? The replacement wasn't drilled to match my table. But this is a lower priority, I didn't have a motor drive on my old mill and used that for around 20 years, often on long items.? Good exercise.

Finish the adapter for 4 jaw chuck?

?

?

Dave?

?

.

I upgrade bolt a by two 3m bolts

Now it has a AHCS BOLT.

See the center?

?

?

The chuck came with a adaptor to a drill?

I took and drill and tap for seen in last photo

?

?

?

Dave?

Here the chuck bolt to the rotary table.?

The apdator has pilot on to if into the tablet. This use outside of for easy setup.

?

Dave?

?

?

?

?