Mini lathe 7 x12 14 8 shop drill press mill wood working sextant clocks gear milling equipment engine tractor rebuilding repair Milling on a Mini Lathe
|
Clamping an angle plate or stop in place. Bill in OKC? William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by: Good judgement comes from experience. Experience comes from bad judgement.? SEMPER GUMBY! Physics doesn't care about your schedule. The only reason I know anything is because I've done it wrong enough times to START to know better. Expect in one hand, expectorate in the other. See which one gets full first.
On Friday, February 14, 2025 at 10:49:50 PM CST, davesmith1800 <davesmith1@...> wrote:
Any know how this tee slot use for ?
It about Suze if a #6 screw
?
Dave
|
|
To me the tiny tee slot is not useful.??
I even on Tiag website to see if they show anything on tee slot nothing.?
It is lessthan ?" [3mm] wide maybe wider.
?
I am thinking some very important to spend all that time making a tiny tee slot that is not used. Even on copies
?
More photos?
You see no tap hole for a stop on side and tee slot is both sides. The copies of the Tiag Mill ATTACH has the same tee slot
?
On Sat, Feb 15, 2025 at 09:13 AM, Bill in OKC too wrote:
|
Bill in OKC too
davesmith1800