开云体育

I first was looking at mini lathe in 2005. Use making bushings for portable line boring work { in field } because it is light weight.? Because help reasons it did not happen. . For me it fun

Here a few more photos of Tiag mill Attachment.

It is indeed. I've got an older MicroMark 7x14 that I'll drag out of storage when I move into an apartment that isn't so tiny. I mostly use the larger lathes we have at work, because I'm not quite so

The mini lathe is great for gunsmith? work. The mini lathe can have a full length tapper attachment.? It work like tapper attachment from 1900. I have talk to you pass about your name? Hi again

Most of what I do is Gunsmithing work. Doug Yahoo Mail: Search, Organize, Conquer

Someone told me one time she thought machine shops were the most wasteful industry ever because we made stuff out of stuff after throwing some of it away. I guess no one ever told her that we seldom

Laughs, I hear ya, however, we are still talking a hand drill mounted to a boring bar holder if we are going to split hairs? grins~~~~

If the tooth on the end of the bolt is ground to one side at one half gear pitch, you now have a 120 tooth gear by rotating the bolt.

Logan 922 mods. Command center with an added shop built spindle indexing rig. The control support was designed around existing holes for a collet closer assembly and used the clearance notch in the

South Bend milling slide refurbish. This was from the same arson salvage as the lathe.

1950 Farmall H farm tractor stuff. Remachined the steering gland nut that looked like it had been serviced with a jackhammer. One wired mini alternator install with a proper wrench-flatted heim

I designed, machined, assembled and tested this chemical ionization electron impact ionizer for a quadrupole mass spectrometer. 304 series stainless steel, nickel screen, machinable ceramic, vespel

I changed the subject line so it's not so long, more in line with other groups.? Hopefully this makes it easier to find things. If there's any issue with this, we can put it back as it was.

The cutoff blade holder for my lathe came with a missing clamp, I would normally grab a piece of drill rod to make something like that but that was on the other side of the ocean. Here I have to

To me the tiny tee slot is not useful. I even on Tiag website to see if they show anything on tee slot *nothing*. It is lessthan ?" [3mm] wide maybe wider. I am thinking some very important to

Clamping an angle plate or stop in place. Bill in OKC? William R. Meyers, MSgt, USAF(Ret.) Aphorisms to live by:Good judgement comes from experience. Experience comes from bad judgement.?SEMPER

I have tee slot It good size maybe for a ? [14mm] bolt. This one is less than a #5 [4mm] screw just to small even for a stop in my view. I am use to a lot bigger too where using ? bolts and a