开云体育

Updat for Feb 26 2025

*More photos* *Please note the lathe is angle for the wheelchair machinist* *?? ?? ?* ** ?? ?? ? ** ?? ?? ? **

*Lathe setup for Wheelchair .* *It angle and high setup for a Wheelchair ?* *Please post your ideas ?* **

*Photos of machine shop in 24" kitchen cabinet plan to be in a Armoire* *as remember* Dave

Here the one I purchased in 1970’s from Rutland Tool supplies Rockwell test disk Spare bag of ballsnever open

Did little more on getting the size down. The pdf has better details.? A few thing remove for better viewing. Dave

Here photos of my cross feed exstension. I polished by using the threading die chuck die in the lathe chuck. Then screw thread in the tailstock.? Put the on slow and ran the die over the thread over

New drawings on the build For better details see pdf copy

I also have it DWG file too. Dave

Here a pdf copy very clear Dave

Dave, This drawing is very blurry because the resolution is so low, only 488 pixels wide.? It should be at least 1024 wide.? Unless somehow you're reducing the resolution before emailing, you

This what looking at to build What do youthink? Dave

*The best I seen.* *More into land I get with 20 seconds on ground or 2,000 feet.* *I never tried on ocean only by reading* *Dave*

I have yet to get any Flat Earth people explain to me how a sextant works on their version of the disc Earth.? Do you sight on the sun, or the turtle, or the elephants?? The best I can get from them

Sextant tap and see how works . Note hos mirror moves then plumb to the horizon

Here how sextant works

*FYI? Background* I had check class 45 cast iron and would not fit in Rockwell tester. Rutland had a unit for none destruction testing I purchased and very simple . A 3/16 ball from ball bearings.

Photo 1 of 3 different harness charts just uploaded