Keyboard Shortcuts
ctrl + shift + ? :
Show all keyboard shortcuts
ctrl + g :
Navigate to a group
ctrl + shift + f :
Find
ctrl + / :
Quick actions
esc to dismiss
Likes
Search
Photo Azi-Loop_Complete-2.jpg updated
#photo-notice
Group Notification
The following photos have been updated in the Azi-Loop Self-Supporting Structure for Transportable / DXpedition Use photo album of the [email protected] group. By: Guy Atkins <dx@...> |
Hi Guy
Looks good.. so you are on a hill too..have you noticed any effect facing up hill in directivity/ takeoff angle etc.? What dimensions have you used? Ie tip to tip at widest point please? I am using a homebrew LZ1AQ loop array with delay lines.. However quite curious about the mini k9ay setup.. Regards Simon g0zen |
Hi Simon,
?
I wouldn't exactly call it a hill, but just a slight slope. Still, I did take care to keep the elevated radials level. One one side of the antenna the radials are about one foot above ground, and on the other side they are three and a half feet or so above the lawn.
?
Each loop is 12 feet wide, as I used 2X 6-ft fiberglass supports on either side of the vertical mast. Untensioned width is about 12.1 feet, but when tensioned in use the final width of the lower horizontal portion of each loop is 12 feet.
?
Each radial extends two feet further out, so the entire footprint of my antenna is 16 ft square.
?
73,
Guy
? |
Thanks Guy for the interesting view of your finished AziLoop.
The whole construction is very solid and a good idea for the setup. Even though I plan to bury my radials underground because of the animals, this is all a good help. Are the first results in the medium wave band satisfactory? 73 Christoph — |
Hi Christoph,
?
Yes, I've been please thus far with medium wave results. Besides the excellent nulling available 0-360 degrees of the compass, I am finding that nulls are generally broadbanded and similar to the Wellbrook K9AY phaser setup. This is very advantageous when living at or near the Pacific coast. I am able to orient directional antennas like these with the forward beam towards the trans-Pacifc DX, and all domestic (USA / Canada) signals are reduced to various degrees. This really helps the overseas signal carriers to have better S/N and a chance for audio & IDs.
?
Sensitivity of the Azi-Loop seems more than adequate for weak signal reception. At my location during the night time I am able to use the loop's 18dB preamplifier without any attenuation, or overloading.
?
Solar condx lately has made medium wave DX reception very poor. However, this morning's "dawn enhancement" boost was better than yesterday. There were only a couple Australian stations in audio (612 4QR Brisbane and 792 4RN Brisbane), but also a dozen or more carriers from "DU Land". These were noted in comparison to listed carrier frequencies with a calibrated Perseus SDR and Jaguar Pro software. Interestingly, I had anticipated Asian reception for my unattended recordings, and had preset the Azi-Loop's bearing to 310 degrees (Japan/Koreas). Perhaps if I had set the orientation around 240 degrees I would have had more Aussie stations captured to the SSD for later review.
?
My other SDR, a FDM-S3, works extremely well with this antenna also.
?
I'm planning to set up the Azi-Loop next week at a nearby seaside location (Grayland, Washington) and hope to have improved DX results due to sea gain.... and fingers are crossed for better propagation also.
?
73,
Guy Atkins
Aberdeen, WA USA |
Sensitivity of the Azi-Loop seems more than adequate for weak signal reception.Thanks for your first impressions, just as I suspected. By next week in Grayland, I'm sure the sun will have recovered and you'll be able to reap a good harvest from the Pacific. And with Perseus and Jaguar you have the perfect combination with the AziLoop. 73 Christoph — |
to navigate to use esc to dismiss