开云体育

Hi all, Re-arranged stuff and when I got the Z100 re-attached; nothing. No LED's or anything. Been using it for a number of months with the FT-891 and no problem at all. Has 13VDC at the "inside"

I appear to have had the same issue as Peter. ?Received a replacement chip from LDG’s excellent customer service and everything is working perfectly! ? It actually worked pretty well before but

Hi all, I have a problem with this ATU that stopped working well during a 70 cm band qso with the Yaesu FT-757D which is known to have isolation problems between the UHF and HF ranges causing false

I NEVER use more than 25 watts!

My guess is that after having to repair a bunch of FT8-abused tuners, they revised the manual. My recommendation is to follow the latest manual revision regardless of your tuner's age. 73, Kent K9ZTV

A previous post from 2022 says AM/FM ratings are 30W.

My tuner, firmware ver 1.3, bought in October 2024 from HRO came with the "MANUAL REV B" with the following specifications: ".1 to 125W SSB and CW peak power, 30W watts on PSK and digital modes, and

I own the Z11 Pro II and use it with my IC705. ?Yes, it works with a TRS cable and the tune button. ?IIRC, my one complaint with this configuration is that the radio doesn’t lower the power to

Thanks for the replies and confirmation about the compatibility of the Z11 Pro with the Tune function of the Icom 705. 73, IZ4MJP Franco

My error: The 705 does have a Tuner jack.?? My apologies... Ed - ad7gr Just found an answer for you via the group by VA3CJO - Chris "CJ" 05/27/24?? #2011

Farnell: 73, Jan Sent: 04 March 2025 20:53 To: [email protected] Subject: [ldgelectronics] At-1000 burn capacitor Good afternoon, I have a problem in 80m the condenser has burned, do you know

I have used the Z100plus with tht IC705.? HRO sells it with cables for the IC705, the coax (BNC to PL25)? and tuner control cabl).? You connect the control cable to the TUNER output of the IC705

Call or email LDG electronics for the part. Support: To ask a technical or support question please Click HERE ( https://www.ldgelectronics.com/contact-us ) to contact us via E-Mail or Call

Look at RF parts and see if they have the value you need......500V mica.. I would replace all of the (C7) caps that are in parallel with the burnt one. Most likely they all have been overstressed with

Good afternoon, I have a problem in 80m the condenser has burned, do you know where I can find spare parts?

Dear Franco, My 705 only has speaker mic and key trs jacks.?? However, you do not need a trs cable, just connect your radio and antenna coax to the Z-11 Pro II and when you TX the tuner will tune;

Sorry if this question has been posed but i couldn't find an answer. I'd like to bough an Z11 Pro II tuner for my Icom 705. The AH 705 is very expensive and support only 10 Watt. The Z11 Pro II could

FWIW, I own four standalone auto-tuners, including two from LDG and I've never felt the need to directly interface them to a rig. Just a half second of low level carrier is enough to get them to

I am borrowing an AT-11mp, it doesn't like 160, 80 and won't tune, however, if I manually tune it I can get low SWR. better than 1.5:1, then if i change freq a little it will tune............. if I

nice, thanks Roger, James