开云体育

Hello Everyone, After I posted, I did some additional experimenting and found that performing a " Power-On Microprocessor Reset" on my Yaesu FT-817nd corrected the issue.? The procedure will reset

Since my topic is not showing, i will describe one more time . Hope somebody can explain me this : My rig (TS870s) antenna port is connected in standard way to AT-100PROII. Then tuner ANT1 output is

Good Day Thomas and group, Apologies for resurrecting this thread but I am having exactly the same issue with a Z-817 I just purchased.? I was wondering if you were able to solve the problem you were

Thanks Dwayne for reply and info LDG links much appreciated 73 Dave 2E0DTB [email protected]> wrote:

Hi Dave, It's possible relay K-17 has partially gone out. I'd contact LDG directly to get a replacement part and/or return info. https://www.ldgelectronics.com/contact-us Best, Dwayne Kincaid WD8OYG

Hi guys, is it possible for antenna port 1 circuitry to go down,I was on my ic 7000 on 40meter band ,I have the icom interface cable from radio to tuner tuning up radio display disappeared from screen

Angle brackets attached to rack mount Roydan N0RTT [email protected]> wrote:

Yes. Box has metal shelves,? used angle aluminum to make bracket. Easy.? Sent from AOL on Android On Fri, Sep 20, 2024 at 4:32 PM, John Dean (K0JDD) via groups.io<k0jdd@...> wrote:

well, I am a day late....... Out cutting and cleaning tails for the upcoming 4X4 event. I learned the hard way to not ground the chassis. When using it as a tuner for my backpack radio set, it would

I use padded and reusable ZIP ties from KF7P.com <http://kf7p.com/> Cinches down snug but can be released and re-used. Thomas KF7RSF/NNA0WL

3M Command Strips

I know this is a desktop device,? but has anyone mounted an AT100PROii on a shelf in a go box? HOW did you mount it? * Make a bracket? * 2" velvro? * Tie wraps? * Other Looking for ideas that will

Thanks for the link. Was just about to order one when I found it!?Blame it on old age. Dick W4RSS

Please see link for current LDG cable. https://www.ldgelectronics.com/y-acc-1-interface-cable

I cant find my interface able to go between the Z-11PROII and my f-891. Is one available commercially, or will any 3ring male to male cable to the job" Thanks, Dick W4RSS

As per the manual, antenna port 2 is the pass through port on the at600 and at1000 _______________________ Scott A Scheirer KC3PCS (Amateur Radio Extra Class) WRPF656 (GMRS) scott@...

Hello, It's no issue because it's switch relay , the ldg must be power on. Why , you want to switch off. For me, it's always in by pass mode .. Best regard Sylvain Marcotte (VE2CSM) 104 Rue Piché

I found this to be true in a lot of applications. The fold back doesn't come from the tuner but, it's your rigs "self preservation" kicking in. Some set-ups do lower the tune power. These are the ones

The issue is that Yaesu doesn't support it in their firmware.

Amen! I have an 891 and Z11 ProII - connected by that cable - that I use in my shack, and I’ve seen plenty of references - including one by a very popular Wisconsin-based YouTuber - that tout the