开云体育

I don't understand why anyone would pay scalper prices for this item. On both Gigaparts and DX they will sell for under $13 and, even though they too are sold out, they sell for $10 on LDG's site. I

Opps!! Miss read the manual . . . sorry. But still won't pay 4x's the price for them.

But wait, there's more..... On power up, the RT-600 will not tune upon application of RF power, nor will it retain the last good tune.? The SWR is always high right after powering up.? It is as if

Got it too. I don’t need it – NOW. But I have two RT-100s here, neither being used right now…….. and it may come that I need a schematic someday. THANKS EVERYONE !!! Vy73 – Mike – KD5KC

Thanks a million AL. Found what I needed... Dennis N0SMX

The schematic is in the Files Section on here. Al K5TAN Sent: Saturday, March 11, 2023 3:37 PM To: [email protected] Subject: Re: [ldgelectronics] RT 100 schematic Mike thanks but I have the

Mike thanks but I have the manual also. I bought this tuner new in 2016.. If I find a schematic I'll share it with you.. Mostly what I'm finding out is non exist for public distribution.... Dennis

I have the manual in .PDF, I’ll share if you need it. I have no schematic. If anyone does and will share….. Please—ME TOO! Vy73 – Mike – KD5KC – WRFF851 – El Paso – Texas – DM61rt.

I have found some of these cables on eBay. Your mileage may vary. Phil Laird, WI5O

Does anyone have a schematic for the LDG RT 100 remote tuner. I have an issue with mine and found a burned resistor on the board.? I can't determine the valve to replace it with.. Thanks in advance

Still on a national backorder.? No ETA from LDG as to when they may become available.? You may see some dates listed on some of the retailer websites but that is generally just an computer algorithm

I would also like to use a LDG 1000 with a FTdx 3000 but would like to use the TUNER port on the radio instead of the LInear (15 pen) port.

did you go into the operation settings and change the internal tuner settings?? Dave Garber VE3WEJ / VE3IE

Hello, I'm back with some additional questions about EXPECTED behavior vs ACTUAL behavior. I built the cable I shared the schematics for a few weeks ago. I thought it was working properly, but I'm

Yes the LDG tuners are not SDR, the firmware is in ROM or PROM, an IC. Many of their now on the market tuners have been around for a while and I am sure there have been some changes, but I dont LDG

Ian: Just fyi the 1000's built after October 2021 they disabled the port that the meter plugs into, I found this out the hard way, so if you have one built after Oct21 the M-1000 meter will not work

Does anyone know if the M-1000 meter will become available again? Or is a replacement planned? I can’t find one at any dealers in Europe. Would like one to match my At-1000 pro2. ? regards Ian

I have an LDG 600 ProII. I had it in manual mode which I had to retune everytime I changed bands. This worked well for me. Reading the service manual I *learned how to put it in automatic mode. I did

I was just reading my AT-200Pro tuner manual; it stated how to read firmware level (button press combination on power connect-read display segments) and that if there was an upgrade you would have to

in? the files section of this group is file called? "LDG tech notes" it is zip file ...in here is method for calibration which only address swr calibration\ BUT swr is what drives auto tune