开云体育

I have the AT1000 ProII, it has been doing odd thing lately, to turn it off, I have to hold the Power button down, relays cycle a few times, then the unit powers off. The thing still works FB though.

All Reset: Press and hold Func + Ant + Tune while applying DC power. This will reset the unitto factory defaults, and will erase all frequency memories. The AT-200/AT-100 Pro II do not have a reset

Please share how to reset the tuner, thanks. John VE3KKQ

Oh yeah - it's a treat. I put something heavy on top of mine so it wouldn't run away, then made sure my fingers weren't going to cramp up. After a couple tries I got it, and in my case it fixed the

Hi Mike (KD9CK), Have you ever tried to reset an LDG? I did a while back and I could have done with a third hand, hi hi. 73 de Guy G4DWV 4X1LT

As long as you have the AT-200 Pro and not the ProII try this first: All Reset: Press and hold Func + Ant + Tune while applying DC power. This will reset the unitto factory defaults, and will erase

Absolutely..... LDG has proven to have very good service... best 73 Tony KA8UGB Tony (KA8UGB) New Buffalo Michigan (269) 207-1524 Sent from my Verizon, Samsung Galaxy smartphone Get Outlook for

Wondering here ... on the subject of why the Z100+ will tune bands the AT 200 Pro will not ... I bought the AT 200 Pro used ... It could be possible something about it might be "wrong" and the seller

Tony, My experience was the same as na6mb's; I sent my LDG AT-100 Pro II back to LDG for service.? Turn around was fairly decent and they didn't charge me any repairs or bench time. Good luck, Terry,

One feature of the ProII missing from the Pro is the LED for Active or Bypass. Any idea if the Pro can be modified to have that LED? Just need to know where the signal is present on the PCB and I can

AT1000Pro stooped allowing Bypass / Active switch. Sent in to LDG. Fixed and did a SW update for little or no cost. Biggest expense was shipping. NA6MB

Pedro, thanks for the reply. I have tried the reset procedure with no change. However, I did notice something different today.? I have a 40m halfwave dipole, and when I tune on the 40m band, it does

Hi Brad At manual explain something about it but I don't know if it will help.you. i hope yes: Expert Button Your AT-7000 has a control button and LED inside the case that may prove useful in certain

Hello, I got a used LDG AT-7000 autotuner to use with my Icom IC-718.? The previous owner added a manual tune button to it by connecting a button to the pins on the radio port.? Otherwise no obvious

Hi Ed & all, I cehcked and cleaned the connectors and it looks work better. I'll work on it a few more in some days. Regards,

Don’t feel limited by making the wire a straight run. I have a mobile home and a 117’ end fed exactly as yours is setup with the 9:1. I also have a 1:1 where the coax connects to the 9:1 and

John, FYI... 65' is a length to be avoided for an end fed wire antenna since it will result in high impedance at your matching unit. Helpful references are: http://udel.edu/~mm/ham/randomWire ,

I this basic set up for my stealth antenna in my HOA neighborhood. (Diagram below) I can tune 80m thru 6m with my Z100+. ?But, I was tired of manually having to hit the tune button on the Z100+ and I

Thanks Ed, I'll check all connectors and connexions or may be change some of them. Regards,

Pedro, I've a friend who had a similar problem. After replacing loose rivets with screws on the SO-239 the problem went away. Also check your coax, PL-259s, and anything else in the antenna system.