开云体育

the package from ldg that the cable comes in, shows that acc-1 is for the 710. I did tell hro of the descrepency and they kindly replaced the acc-2 with the acc-1 at no charge for me.

Thanks. My confusion came from a chart on the HRO website that indicated that the ACC-2 cable was the one to use with FT-710 [email protected]> wrote:

Ok great information, I am waiting on them to get back to me, as I have a at-1000pro 2 that doesn't work on the meter/pc TTL port, as they now sell them with it switched off, in firmware, I hope that

I did contact LDG ,quick reply they said that the firmware hadn't any issues since its release but if I have any problems, to reach out to them ,brilliant support,Dave 2E0DTB 73

I use the ACC-1 with my FT710 and the AT1000PRO2. Works well. I don't believe the ACC-2 will work with the FT-710.

according to the package that the acc-2 came in, you should use the acc-1 for the 710 Phil

I posted this as a reply to a mental mish mash of the unun post and this one.? I have cleaned it up as to this post, and re-posted here. As previously pointed out, the choice of ratio depends on the

Does the tune work now or only as a 12V source?

Hi no worries, Dave 2E0DMB

Wow thanks Dave ,for info much appreciated ,Dave 73 2E0DTB D T Bradley

Hi David Yes it can, Open up your tuner and write down the number on the label on the IC and go on there website and fill out the form, Dave 2E0DMB

Can my above tuners firmware be updated,I wasn't aware that ldg tuners could be updated ,Dave 2E0DTB 73 just curious,TIA

Can my above tuners firmware be updated,I wasn't aware that ldg tuners could be updated ,Dave 2E0DTB 73 just curious,TIA

Does the mean the Y-ACC-2 cable does not work with the FT-710?? HRO's website has a link to a chart on the AT-200Pro II page that says it's the right cable, but in the store they have a chart from

There is something be said about what the SWR is to start with. An SWR of say, 4 to 1 may mean z of 200 or z of 12.5. The tuner may be happy with the 200 being quartered to 50, but not with the 12.5

Using the same Power Supply with a fused distribution block! Terry

Thank you! -- 73 W4NDK

In short, yes. I have a distribution block distributing power from my ICOM switching power supply to my RC/RT-600, my RIGblaster audio interface and my ct-17 serial to CI-V driver. Al K5TAN

Certainly you can do so.

There is a very unprofessional video I just did on the subject now that I. Rewatch it I probably should have took notes on a piece of paper and could have trimmed it down to a 3 minute video. Hi Hi